ProForm PFEL79907.1 user manual Assembly

ASSEMBLY

To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the

included hex keys, assembly requires a Phillips screwdriver , an adjustable

wrench , and a rubber mallet .

As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre- assembled. If a part is not in the hardware kit, check to see if it has been preassembled.

Star Washer	M4 x 13mm	M6 Split		M8 x 15mm x 4.5mm		M8 Split		Wave Washer
(100)–3	Washer (93)–2	Washer (88)–8		Washer (99)–4		Washer (72)–4		(98)–8
								M4 x 16mm
M10 x 20mm x	M10 x 25mm			M8 Nylon		M10 Nylon		Self-tapping
1mm Washer	Washer (94)–10		Locknut (96)–4		Locknut (97)–2			Screw (79)–16
(81)–2
M4 x 16mm	M6 x 35mm Phillips			M8 x 16mm Patch		M8 x 42mm Bolt
Screw (86)–8	Screw (87)–8			Screw (95)–3				(71)–4
	M8 x 75mm Patch			M10 x 20mm Patch			M10 x 23mm Shoulder
	Screw (107)–4			Screw (91)–10				Screw (80)–2
M10 x 62mm Patch Bolt (89)–2				M10 x 78mm Patch Screw (90)–2
				5