JVC UX-A52 Setting the Clock, Using Recording Timer, How Recording Timer actually works, English

English

There are three timers available—Recording Timer, Daily	When you unplug the AC power cord or if a power
Timer, and Sleep Timer.	failure occurs
You need to set the built-in clock to use these timers.	The clock setting will be reset to “0:00.” If this happen, you need to
	set the clock again.

Setting the Clock

You can set the clock whether the unit is turned on or off (on standby.)

On the remote control ONLY:

1 Press CLOCK/TIMER repeatedly until “TIME ADJUST” appears on the display.

The hour digit starts flashing on the display.

2 Press ¢ or 4 repeatedly to adjust the hour.

•When you press and hold the button, the hour digit changes continuously.

3 Press SET to set the hour.

The minute digit starts flashing on the display.

Ex. When pressing SET after

adjusting the hour to 10.

•If you want to correct the hour again, press

CANCEL.

The hour digit starts flashing again.

4 Press ¢ or 4 repeatedly to adjust the minute.

•When you press and hold the button, the minute digit changes continuously.

5 Press SET to finish setting the clock.

The built-in clock starts.

Ex. When pressing SET after adjusting the minute to 10.

To adjust the clock again

Press CLOCK/TIMER repeatedly in step 1 until “TIME ADJUST” appears on the display, then perform steps 2 to 5 above.

To check the clock time by sound while the unit is turned off (on standby)

Press DIMMER while the key-touch tone is set to on. The clock time will be indicated by sound.

Using Recording Timer

With Recording Timer, you can make an unattended recording.

•You can set Recording Timer whether the unit is turned on or off (on standby.)

•To correct a misentry any time during the setting process, press CANCEL.

How Recording Timer actually works

The unit automatically turns on, and starts recording on a tape when the timer-on time comes. (While Recording Timer is working, the REC indicator keeps flashing.) Then, when the timer-off time comes, the recording stops and the unit automatically turns off (on standby.)

Recording Timer works only once, but the timer settings remain stored in memory unless you reset them or unplug the AC power cord.

On the remote control ONLY:

1 Press CLOCK/TIMER repeatedly until “REC TIMER” appears on the display.

The timer ( ) indicator lights, and the REC indicator starts flashing on the display.

Timer indicator

REC indicator REC

Timer mode

•Each time you press the button, the timer mode changes as follows:

REC TIMER DAILY TIMER

Canceled TIME ADJUST

– 31 –