JVC UX-A52 manual English, Setting the AM Tuner Interval Spacing, Tuning in a Station

English

Setting the AM Tuner Interval Spacing

Some countries space AM stations 9 kHz apart, and some countries use 10 kHz spacing.

When shipped, the built-in AM tuner is set to 9 kHz spacing. You can change it to 9 kHz or 10 kHz spacing.

On the unit ONLY:

To set the AM tuner to the 10 kHz spacing, be sure that the unit is turned off, but is plugged into a wall outlet.

While holding ¢, press STANDBY/ON. The unit turns on and “AM 10 kHz” appears on the display for a while.

To set it back to the 9 kHz spacing, be sure that the unit is turned off, but is plugged into a wall outlet.

While holding 4, press STANDBY/ON. The unit turns on and “AM 9 kHz” appears on the display for a while.

Tuning in a Station

1 Press FM/AM repeatedly to select “FM” or “AM.”

The unit automatically turns on with the last selected station.

•Each time you press the button, the band alternates between FM and AM.

2 Press and hold ¢or 4until the station frequencies start changing on the display.

•¢: to increase the frequencies.

•4: to decrease the frequencies.

The unit starts searching stations and stops when a station of sufficient signal strength is tuned in.

Ex. An FM station is tuned in.

•If an FM program is broadcast in stereo, the ST (stereo) indicator lights on the display.

To stop during searching, press ¢or 4.

When you press ¢or 4repeatedly

The frequency changes step by step.

To change the FM reception mode

When an FM stereo broadcast is noisy or hard to receive, you can change the FM reception mode to improve the reception.

On the remote control ONLY:

Press FM MODE so that the MONO indicator lights on the display.

•Each time you press the button, the MONO indicator lights and goes off alternately.

When the MONO indicator is lit:

Reception improves though stereo effect is lost.

When the MONO indicator is not lit:

You can hear stereo sound when a program is broadcast in stereo.

The ST (stereo) indicator lights while receiving the FM stereo broadcast (only when the reception is good.)

In addition, static noise between stations will be erased while tuning.

Presetting Stations

You can preset 30 FM and 15 AM stations manually.

In some cases, test frequencies have been already memorized for the tuner since the factory examined the tuner preset function before shipment. This is not a malfunction. You can preset the stations you want into memory by following the presetting method.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.

On the remote control ONLY:

1 Tune in a station you want to preset.

• See “Tuning in a Station” to the left column.

2 Press SET.

The preset number starts flashing as follows:

•When you select an FM station in step 1

•When you select an AM station in step 1

Preset No. 1 always appears at first.

– 15 –