Seiko 7K32 manual

(2)Turn crown “1” clockwise to set the 24-hour and minute hands to the time of a desired area. For example, if you are in New York and it is 10:00 PM, set the 24-hour hand to “22” (10:00 PM) and the minute hand to the 12 o'clock position.

Notes:

・The date may change depending on the time that the hour hand indicates. It is not necessary, however, to reset them at this step, as they can be adjusted independently later.

・When setting the minute hand, advance it 4 to 5 minutes ahead of the desired time and then turn it back to the exact time.

※Set the alarm hands to the current time and adjust the barometer hand position. Refer to “Alarm hand setting”.

Refer to “Barometer hand position adjustment”.

(3)Push crown “1” back in to the normal position in accordance with a time signal. Adjustment of the 24-hour, minute and small second hands have been completed.

Notes:

・As the crown “1” is pushed back in to the normal position, the barometer hands indicate the current atmospheric pressure.

・The alarm hands start moving in 1-minute increments correspondingly with the small second hand.

(4)Set the hour hand to the current hour. To do so, first pull out crown “2” to the second click. Notes:

・The alarm hands keep indicating the set time.

・Do not press button C as this will move the alarm hands.

(5)Turn crown “2” counterclockwise to set the hour hand to the current hour.

Notes:

・Check that AM/PM is correctly set by turning the hand past the 12 o'clock marker. If the date changes to the next, the time is set for the AM period. If the date does not change, the time is set for PM period.

・The hour hand moves in 1-hour increments.

(6) After setting the hour hand, push crown “2” back in to the normal position.

The time setting procedure for “Method 2” has been completed. To set the 24-hour hand to the time of another area in a different time zone, repeat the steps from (1). For the time differences among cities throughout the world, refer to the table of time differences in “Time difference adjustment”. (Refer to “Time difference adjustment”.)

Note:

・After the time setting for “Method 1” or “Method 2” is completed, check the date is properly set, and reset them if necessary. (Refer to “■HOW TO SET THE DATE.”)

55 56