Connecting Other Equipment | Now, you can plug the AC power cord. |
|
|
You can connect both analog and digital equipment.
• DO NOT connect any equipment while the power 
is on.
•DO NOT plug in any equipment until all connections are complete.
To connect an analog component
Be sure that the plugs of the audio cords are colored: White plugs and jacks are for left audio signals, and red ones for right audio signals.
AUX
RIGHT LEFT
Audio equipment
To audio output
For playing the other equipment through this unit,
connect between the audio output jacks on the other equipment and AUX jacks by using audio cords (not supplied).
To connect audio equipment with an optical digital input terminal
You can record CD sound onto the connected digital equipment.
CD OPTICAL | Protective |
DIGITAL | |
OUTPUT | |
| plug |
IMPORTANT: Be sure to check all connections to be done before plugging the AC power cord into a wall outlet.
Canceling the Demonstration
When connecting the AC power cord into a wall outlet, the unit automatically starts the demonstration.
To cancel the demonstration, press and hold CANCEL/DEMO until “DEMO OFF” appears on the display.
• To cancel only beep sounds during the
demonstration, press BEEP ON/OFF on the remote control.
When you press other buttons
The demonstration stops temporarily. It will start automatically again (if no operation is done for 2 minutes) unless you cancel it by pressing CANCEL/DEMO.
To start the demonstration manually
Press and hold CANCEL/DEMO again until “DEMO START” appears on the display.
To optical digital input
Before connecting the other equipment, remove the protective plug from the terminal.
Audio equipment with an optical digital input
Connect an optical digital cord (not supplied) between the optical digital input terminal on the other equipment and the CD OPTICAL DIGITAL OUTPUT terminal.
– 9 –