JVC GVT0077-008A manual Using the Timers, Using Daily Timer, How Daily Timer actually works

Using the Timers

There are three timers available—DAILY (Daily Timer), REC (Recording Timer), and SLEEP (Sleep Timer).

Before using the timers, you need to set the clock built in the unit. (See page 10.)

Using Daily Timer

With Daily Timer, you can be awaken with your favorite music or radio program.

You can set the timer whether the unit is on or off; however, if Ecology Mode is activated, you cannot set the clock while the unit is off.

On the unit ONLY:

1 Press CLOCK/TIMER	/ TIMER
	CLOCK
repeatedly until “DAILY”
appears on the display.

(Timer) indicator lights up and the DAILY

(Daily Timer) indicator also starts flashing on the display.

D A I L Y

•Each time you press the button, the timer setting modes change as follows:

How Daily Timer actually works

The unit automatically turns on, sets the volume level to the preset level, and starts playing the specified source when the on-time comes (“DAILY” and the DAILY (Daily Timer) indicator flash just before the on-time, and the DAILY (Daily Timer) indicator continues flashing while the timer is operating). Then, when the off-time comes (“DAILY OFF” flashes just before the off-time), the unit automatically turns off (on standby).

		DAILY		TIMER		REC
			(Daily Timer setting)
	Canceled			Clock		TIMER
				setting	(Recording Timer setting)
		(The hour digits start flashing.)
2 Press CLOCK/TIMER again.							CLOCK
							/ TIMER

“TIMER” appears for 2 seconds, then the unit enters on-time setting mode.

D A I L Y

The Daily Timer works everyday automatically. If you do not want to use the Daily Timer, turn off the Daily timer. (See “To turn on or off Daily Timer after its setting is done” on page 26.) The timer setting remains in memory until you change it.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

•To correct a mis-entry while setting the timer, press

CANCEL/DEMO.

Before you start...

3 Set the on-time you want the unit to turn on at.

1)Turn 4/ ¢ to set the hour, then press SET/DISPLAY.

2)Turn 4/ ¢to set the minute, then press SET/DISPLAY.

“SET” appears for 1 second, then

the unit enters off-time setting mode.

PR	E
	SET

SET /

DISPLAY

•When using a CD as the source to play—

–Make sure there is a CD on the selected disc number tray.

•When using a tape as the source to play—

–Make sure that a tape is in the cassette deck.

–Make sure that the tape direction is correct.

•When using the external component as the source to play—

–Set the timer equipped on the external component at the same time.

D A I L Y

– 25 –