JVC GVT0077-008A manual Important for Laser Products, Important for the U.K

Page 2

Warnings, Cautions and Others

IMPORTANT for the U.K.

DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appro- priate safety approved extension lead or consult your dealer.

BE SURE to replace the fuse only with an identical approved type, as originally fitted.

If nonetheless the mains plug is cut off ensure to remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent connection to the mains supply.

If this product is not supplied fitted with a mains plug then follow the instructions given below:

IMPORTANT:

DO NOT make any connection to the terminal which is marked with the letter E or by the safety earth symbol or coloured green or green-and-yellow.

The wires in the mains lead on this product are coloured in accordance with the following code:

Blue : Neutral

Brown : Live

As these colours may not correspond with the coloured markings identifying the terminals in your plug proceed as follows:

The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.

The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.

IF IN DOUBT - CONSULT A COMPETENT ELECTRICIAN.

Caution–– (standby/on) button!

Disconnect the mains plug to shut the power off completely. The

(standby/on) button in any position does not disconnect the mains line. The power can be remote controlled.

Caution

To reduce the risk of electrical shocks, fire, etc.:

1.Do not remove screws, covers or cabinet.

2.Do not expose this appliance to rain or moisture.

IMPORTANT FOR LASER PRODUCTS

REPRODUCTION OF LABELS

1CLASSIFICATION LABEL, PLACED ON REAR ENCLOSURE

2WARNING LABEL, PLACED INSIDE THE UNIT

1.CLASS 1 LASER PRODUCT

2.DANGER: Invisible laser radiation when open and interlock failed or defeated. Avoid direct exposure to beam.

3.CAUTION: Do not open the top cover. There are no user serviceable parts inside the Unit; leave all servicing to qualified service personnel.

CAUTION

Do not block the ventilation openings or holes.

(If the ventilation openings or holes are blocked by a newspaper or cloth, etc., the heat may not be able to get out.)

Do not place any naked flame sources, such as lighted candles, on the apparatus.

When discarding batteries, environmental problems must be considered and local rules or laws governing the disposal of these batteries must be followed strictly.

Do not expose this apparatus to rain, moisture, dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus.

Caution: Proper Ventilation

To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows:

1 Front:

No obstructions and open spacing.

2 Sides/ Top/ Back:

No obstructions should be placed in the areas shown by the dimensions below.

3 Bottom:

Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm or more.

Front view

 

 

15 cm

 

15 cm

1 cm

1 cm

15 cm

10 cm

Side view

15 cm

15 cm

G-1

Image 2
Contents CA-HXZ1R Important for Laser Products Important for the U.KAbove ALL About This Manual PrecautionsIntroduction Contents Front Panel Location of the Buttons and ControlsFront Panel Display Window Remote Control For CA-HXZ1RFor CA-HXZ1 Getting Started Supplied Accessories Connecting AntennasPutting the Batteries into the Remote Control FM antenna To connect an outdoor FM antennaTo connect an outdoor AM antenna Connecting SpeakersAM antenna Close the speaker terminalsTo connect an analog component Connecting Other EquipmentCanceling the Demonstration To start the demonstration manuallySaving the Power Consumption while on Standby -Ecology Mode Turning On or Off the PowerSetting the Clock Common OperationsSelecting the Sources Adjusting the VolumeTo turn down the volume level temporarily Reinforcing the Bass SoundTurning On or Off the Key-touch Tone Creating Your Own Sound Mode-User ModeTo use your own sound mode Presetting Stations Tuning in to a StationTuning in to a Preset Station To change the FM reception modeChanging the RDS Information Press Display ModeSearching for Programs by PTY Codes PTY Search Press PTY SearchTo activate the Enhanced Other Networks function Switching to a Program Type of Your Choice TemporarilyWait for about 5 seconds after specifying the data type More about the Enhanced Other Networks functionLoading CDs When playing a CD-R or CD-RWPlaying Back CDs CD/CD-R/CD-RW About the CD ready lampsBasic CD Operations Programming the Playing Order of the Tracks -Program Play To modify the program To check the program contentsPlaying at Random-Random Play Prohibiting Disc Ejection-Tray Lock To cancel the prohibition and unlock the CDs, press 0forRepeating Tracks or CDs-Repeat Play If you try to eject CDs while Tray Lock is in usedLocating the Beginning of a Song-Music Scan Playing Back TapesPlaying Back a Tape Recording on a Tape To record on both sides-Reverse ModeRecording To keep the best recording and playback sound qualityPress CD REC Start CD Synchronized RecordingCD Direct Recording Record from Reverse Mode indicator lights Up likePress Edit How Daily Timer actually works Using the TimersUsing Daily Timer When selecting 1 CD Daily Timer settingWhen selecting Tuner FM or Tuneram Volume levelUsing Recording Timer How Recording Timer actually worksTo turn on or off Recording Timer after its setting is done Using Sleep TimerTimer Priority How Sleep Timer actually worksAdditional Information Description of the PTY codesGeneral Notes MaintenanceCleaning the unit Handling discsTroubleshooting SymptomSpecifications CA-HXZ1R0302MWMMDWJEM SP-HXZ1 Specifications ConnectionTechnische Daten AnschlussRaccordement CaractéristiquesTechnische Gegevens AansluitingenConexión EspecificacionesSpecificazioni CollegamentoAnslutning Tekniska DataSpecifikationer TilslutningLiitäntä Tekniset Tiedot