JVC GVT0077-008A Listening to FM and AM Broadcasts, Tuning in to a Station, Presetting Stations

Page 16

Listening to FM and AM Broadcasts

Tuning in to a Station

 

On the unit ONLY:

 

 

 

1 Tune in to the station you want to preset.

1 Press FM/AM.

 

FM / AM

• See “Tuning in to a Station.”

 

The unit automatically turns on and tunes

 

2 Press SET/DISPLAY.

 

in to the previously tuned station (either

 

DISPLAY

 

 

 

 

 

SET /

FM or AM).

 

 

 

 

 

 

 

 

 

 

• Each time you press the button, the band

 

 

 

 

 

alternates between FM and AM.

 

 

 

 

 

2 Start searching for stations.

On the unit:

Press and hold TUNING + or TUNING – for more than 1 second.

On the remote control:

Press and hold ¢(Á) or 4(1) for more than 1 second.

The unit starts searching for

stations and stops when a station of sufficient signal strength is tuned in.

•If a program is broadcast in stereo, the ST (stereo) indicator lights up.

To stop searching, press TUNING + or TUNING – (or

¢(Á) / 4(1) on the remote control).

When you press TUNING + or TUNING – (or¢(Á) / 4(1) on the remote control) briefly and repeatedly

The frequency changes step by step.

3 Turn PRESET + / – to select a

 

 

 

E

preset number.

 

 

 

PR SET

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

4 Press SET/DISPLAY again.

SET /

 

 

 

DISPLAY

 

 

 

 

 

 

 

 

 

 

 

 

The tuned station in step 1 is stored in the preset number selected in step 3.

•Storing a new station on a used number erases the previously stored one.

When you unplug the AC power cord or if a power failure occurs

The preset stations will be erased in a few days. If this happens, preset the stations again.

To change the FM reception mode

 

On the remote control ONLY:

 

When an FM stereo broadcast is hard to receive

FM MODE

or noisy, press FM MODE so that the MONO

 

indicator lights up on the display. Reception

 

improves.

 

To restore the stereo effect, press FM MODE again so that the MONO indicator goes off. In this stereo mode, you can hear stereo sounds when a program is broadcasted.

Tuning in to a Preset Station

1 Press FM/AM.

FM / AM

The unit automatically turns on and tunes in to the previously tuned station (either FM or AM).

•Each time you press the button, the band alternates between FM and AM.

Presetting Stations

You can preset 30 FM and 15 AM stations.

In some cases, test frequencies have been already memorized for the tuner since the factory examined the tuner preset function before shipment. This is not a malfunction. You can preset the stations you want into memory by following the presetting method.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.

2 Select a preset number.

On the unit:

Turn PRESET + / –.

On the remote control:

Press the number buttons.

Ex.: For preset number 5, press 5. For preset number 15, press

+10, then 5.

For preset number 25, press +10, +10, then 5.

For preset number 30, press +10, +10, then 10.

PRESET

1 2 3

4

5

6

7 8 9

10 10

– 13 –

Page 15 Page 17
Image 16
Page 15 Page 17
Contents CA-HXZ1R Important for Laser Products Important for the U.KAbove ALL Introduction PrecautionsAbout This Manual Contents Front Panel Location of the Buttons and ControlsFront Panel Display Window Remote Control For CA-HXZ1RFor CA-HXZ1 Supplied Accessories Connecting Antennas Putting the Batteries into the Remote Control FM antennaGetting Started To connect an outdoor FM antennaConnecting Speakers AM antennaTo connect an outdoor AM antenna Close the speaker terminalsConnecting Other Equipment Canceling the DemonstrationTo connect an analog component To start the demonstration manuallyTurning On or Off the Power Setting the ClockSaving the Power Consumption while on Standby -Ecology Mode Common OperationsAdjusting the Volume To turn down the volume level temporarilySelecting the Sources Reinforcing the Bass SoundTo use your own sound mode Creating Your Own Sound Mode-User ModeTurning On or Off the Key-touch Tone Tuning in to a Station Tuning in to a Preset StationPresetting Stations To change the FM reception modePress Display Mode Searching for Programs by PTY Codes PTY SearchChanging the RDS Information Press PTY SearchSwitching to a Program Type of Your Choice Temporarily Wait for about 5 seconds after specifying the data typeTo activate the Enhanced Other Networks function More about the Enhanced Other Networks functionWhen playing a CD-R or CD-RW Playing Back CDs CD/CD-R/CD-RWLoading CDs About the CD ready lampsBasic CD Operations Programming the Playing Order of the Tracks -Program Play Playing at Random-Random Play To check the program contentsTo modify the program To cancel the prohibition and unlock the CDs, press 0for Repeating Tracks or CDs-Repeat PlayProhibiting Disc Ejection-Tray Lock If you try to eject CDs while Tray Lock is in usedPlaying Back a Tape Playing Back TapesLocating the Beginning of a Song-Music Scan To record on both sides-Reverse Mode RecordingRecording on a Tape To keep the best recording and playback sound qualityCD Direct Recording CD Synchronized RecordingPress CD REC Start Press Edit Reverse Mode indicator lights Up likeRecord from Using Daily Timer Using the TimersHow Daily Timer actually works Daily Timer setting When selecting Tuner FM or TuneramWhen selecting 1 CD Volume levelUsing Recording Timer How Recording Timer actually worksUsing Sleep Timer Timer PriorityTo turn on or off Recording Timer after its setting is done How Sleep Timer actually worksAdditional Information Description of the PTY codesMaintenance Cleaning the unitGeneral Notes Handling discsTroubleshooting SymptomSpecifications CA-HXZ1R0302MWMMDWJEM SP-HXZ1 Specifications ConnectionAnschluss RaccordementTechnische Daten CaractéristiquesAansluitingen ConexiónTechnische Gegevens EspecificacionesCollegamento AnslutningSpecificazioni Tekniska DataTilslutning LiitäntäSpecifikationer Tekniset Tiedot
Top Page Image Contents