JVC RX-884RBK Analog connections, Connecting Audio/Video Components, Audio component connections

Getting Started

English

Connecting Audio/Video Components

You can connect the following audio/video components to this receiver. Refer also to the manuals supplied with your components. If you want to connect a component not listed in the table below, refer to the manual supplied with it.

Audio Components	Video Components
• Turntable	• DVD player*
• CD player*	• TV
• Cassette deck or MD recorder*	• DBS tuner*

•VCRs

•Video camera

*You can connect these components using the methods described in “Analog connections” (below) or in “Digital connections” (see page 12).

Analog connections

Audio component connections

Use the cables with RCA pin plugs (not supplied).

Connect the white plug to the audio left jack, and the red plug to the audio right jack.

To audio output

Turntable

If an earth cable is provided for your turntable, connect the cable to the screw marked GND on the rear panel.

	RIGHT	LEFT AUDIO
	GND	PHONO
	To audio output
		CD
CD player
		OUT
	To audio input	(REC)
		TAPE
		/MD
		IN
		(PLAY)
Cassette deck	To audio output
or
MD recorder	To audio output

To audio input

If your audio components have a COMPU LINK-3 or TEXT COMPU LINK terminal

•See also page 55 for detailed information about the connection and the COMPU LINK-3 remote control system.

•See also page 56 for detailed information about the connection and the TEXT COMPU LINK remote control system.

CAUTION:

If you connect a sound- enhancing device such as a graphic equalizer between the source components and this receiver, the sound output through this receiver may be distorted.

Notes:

•Any turntables incorporating a small-output cartridge such as an MC (moving-coil type) must be connected to this receiver through a commercial head amplifier or step-up transformer. Direct connection may result in insufficient volume.

•You can connect either a cassette deck or an MD recorder to the TAPE/MD jacks. When connecting an MD recorder to the TAPE/MD jacks, change the source name, which will be shown on the display when selected as the source, to “MD.” See page 18 for details.

9