JVC RX-884PBK manual Attenuating the Input Signal, Adjusting the Subwoofer Output Level

Basic Operations

English

Attenuating the Input Signal

When the input level of the playing source through the analog terminals is too high, the sounds will be distorted. If this happens, you need to attenuate the input signal level to prevent the sound distortion.

Notes:

• This function is available only

for the sources connected

using the analog terminals.

On the front panel only:

Press and hold SOUND SELECT/INPUT ATT. until “INPUT ATT ON” appears on the display.

The ATT indicator also lights up on the display.

Each time you press and hold the button, the input attenuator mode turns on (“INPUT ATT ON”) and off (“INPUT NORMAL”).

You can set input attenuator mode separately for each source.

SOUND SELECT

INPUT ATT.

• This function takes effect only

when the DSP mode is in use.

Adjusting the Subwoofer Output Level

You can adjust the subwoofer output level if you have selected “YES” for the “SUBWOOFER” (see page 19).

Once it has been adjusted, the receiver memorizes the adjustment.

On the front panel:

1.Press BALANCE/SURROUND ADJUST repeatedly until “SUBWFR LEVEL” appears on the display.

The display changes to show the current setting.

2.Turn MULTI JOG to adjust the subwoofer output level (– 10 dB to +10 dB), while the indication of the previous step is still on the display.

From the remote control:

1.Press SOUND CONTROL.

10 keys are activated for sound adjustments.

2.Press SUBWOOFER +/– to adjust the subwoofer output level (–10 dB to +10 dB).

BALANCE/SURROUND

ADJUST

MULTI JOG

SOUND

CONTROL

SUBWOOFER

0+10

FM MODE/MUTE 100+

17