Huffy M5800151 manual FIG a

Page 8

IMPORTANT!

ONCE POLE SECTIONS ARE POUNDED TOGETHER - THEY CANNOT BE TAKEN APART

2. Align poles using alignment marks. First, pound top and middle poles together by bouncing them on a scrap piece of wood on the ground as shown in FIG A. until they no longer move toward pole identification stickers. THEN add bottom pole section and pound together in the same way.

TOP

CAUTION!

THE IDENTIFICATION STICKER IS LOCATED 3-3/4" FROM THE END OF THE POLE. WHEN PROPERLY POUNDED TOGETHER, THE POLE SECTIONS SHOULD HAVE A 2-1/2" MINIMUM OVERLAP, LEAVING 1-1/4"

BETWEEN THE OVERLAPPING POLE AND THE IDENTIFICATION STICKER.

2

alignment mark

MIDDLE

FIG A.

scrap wood (Not Supplied)

IDENTIFICATION

STICKER

middle pole

3-1/2”

3

alignment mark

BOTTOM

IDENTIFICATION
STICKER	1-1/4"
	1-1/4"
	middle pole

4

ID# M5800151 11/05

8

Image 8

Contents

Portable System Height Adjustment Safety Instructions Front Parts List Parts Identifier Actual Size Section a Assemble the Poles That will be used as a reference point in the next stepFIG a Pole assembly clockwise as shown Secure tank struts 21 & 22 to pole Repeat for other sideSawhorse or Support Table If Using Sand Install net Height adjustment from 4-1/2 6-1/2Système portable Manuel de Lutilisateur Herramientas Y Materiales Requeridos Materiali Necessari Höheneinstellung Ajuste DE LA Altura Consignes DE Sécurité Des questions ou des pièces manquantes ? ¿Tiene preguntas o le faltan piezas?Fragen oder fehlende Teile? Domande o componenti mancanti?Wichtig Liste DES Pièces Teileliste #23 Conjunto DEL Elevador Section Inférieure FIG. a Attachez lensemble du poteau au réservoir, comme Fissare al palo i montanti 21 e 22 del serbatoio ID# M5800151 11/05 Vorsicht Avertissement Warnung ¡ADVERTENCIA! Avvertenza