Huffy KA-DV300 manual

Page 20

13. Support pole and base assembly over support table. Carefully slide backboard components onto pole at desired position. NOTE: 3” (7.6 cm) down from top of pole is approximately 10 ft. (3.05 m).

WARNING

WARNING

TWO PERSON MINIMUM

DO NOT LEAVE ASSEMBLED

REQUIRED FOR THIS

UNIT UNATTENDED WHEN

PROCEDURE. NOT

EMPTY MAY TIP OVER.

FOLLOWING

 

RECOMMENDATION MAY

 

RESULT IN BODILY INJURY.

 

16

27

 

27

 

 

22

16

14. While still in the horizontal position, secure hardware as shown and tighten completely.

28

26

21

P/N 214326

8/98

20

Image 20
Contents Write in Your Model Number Required Tools MaterialsOutils Necessaires ’INSTALLATION FrançaisEspañol IBA SU Número DE ModeloHerramientas Necesarias Para LA Instalación ZUR Installation Erforderliche Werkzeuge DeutschItaliano Istruzioni Relative Alla SicurezzaAttrezzi Necessari PER IL Montaggio Benodigd Gereedschap Voor Installatie NederlandsPage 211235 5/97 Advertissment Françaisespañol DeutschAvvertenza Page IMPORTANT! Add Français Do not Over Tighten Français Secure tank struts 13 to pole Français Install net clips Outside ViewFrançais Page Français Inside View Then snap end cap in place. Upright unitFrançais Tie Down Assembly Français Parts List Hardware IdentifierYOU MAY have Extra Parts with this Model Français Liste DES Pieces Español Lista DE PiezasDeutsch Teileliste Italiano Lista Della PartiNederlands Onderdelenlijst