JVC RX-DP20VBK Press the desired button, To use the stored signals, To erase the stored signals

To use the stored signals

When you want to use the stored signals, follow the procedure below.

IMPORTANT:

To operate the other component(s) using this remote control—

•Aim directly at the remote sensor(s) on the target component(s).

–This remote control can send signals at a distance of 7 m (23 feet).

OR

•You can also use the IR signal transmitter connected to this receiver.

–Place the IR signal transmitter so that it is aimed at the remote sensor(s) on the target component(s).

You can operate the other component(s) through the remote sensor on this receiver.

When using the remote control:

–Set the ZONE 1/ZONE 2 (LEARN/TRANSMIT) selector to “ZONE 1” or “ZONE 2” properly.

1.Set the LEARN/TRANSMIT (ZONE 1/ZONE 2) selector to “TRANSMIT (ZONE 1/ZONE 2).”

LEARN	TRANSMIT		LEARN	TRANSMIT
			ZONE 1		ZONE 2
ZONE 1		ZONE 2
For the Zone 1 operations			For the Zone 2 operations

2.Press one of the source selecting buttons (or CONTROL repeatedly) to select the desired remote control operation mode (source).

DVD	DVD MULTI	PHONO	CD
VCR 1	VCR 2	TAPE/MD	CDR
TV/DBS	VIDEO	FM/AM	EXT 7.1CH

3. Press the desired button.

TV/CATV/DBS	VCR 1	/ REW	PLAY	FF/
STANDBY/ON	STANDBY/ON	DOWN	TUNING	UP
		REC	STOP	PAUSE

TV/VIDEO

		EFFECT	TV VOL CHANNEL
1	2	3
		LIVENESS
4	5	6
7/P	8	9
			SET
10	0	+10
RETURN	FM MODE	100+	DVD
			MENU

Notes:

•To operate the TV, CATV tuner, or DBS tuner, set the TV operation mode selector correctly.

•To use the following buttons, you can skip step 2 above.

–TV/CATV/DBS (STANDBY/ON), VCR 1 (STANDBY/ ON), TV VOL +/–, TV/VIDEO, DVD MENU

•To use the following buttons, press DVD MENU first.

–SET, % / fi / @ / #

To erase the stored signals

After erasing the stored signals, preset signals are resumed and you can operate JVC’s components again.

1. Set the LEARN/TRANSMIT (ZONE 1/ LEARN TRANSMIT

ZONE 2) selector to “LEARN.”

ZONE 1 ZONE 2

2.Press and hold EXIT, then press one of the source selecting buttons from which you want to erase the stored signals.

		DVD	DVD MULTI	PHONO	CD
EXIT	and	VCR 1	VCR 2	TAPE/MD	CDR
		TV/DBS	VIDEO	FM/AM	EXT 7.1CH

LEARN

“CLEAR” appears on the display, and all the signals stored in the selected remote mode (source) are erased at the same time.

Notes:

•You cannot erase a signal assigned to a particular button only. Storing a new signal to a particular button erases the previously stored signal.

•To erase the stored signals for “CD DISC,” first press CONTROL to select “CD DISC,” then press CONTROL again while holding EXIT this time.

EXIT

\and

3.Set the LEARN/TRANSMIT (ZONE 1/ZONE 2) selector to “TRANSMIT (ZONE 1/ZONE 2)” to finish the erasing procedure.

LEARN	TRANSMIT		LEARN	TRANSMIT
ZONE 1		ZONE 2
			ZONE 1		ZONE 2
For the Zone 1 operations			For the Zone 2 operations

80