JVC RX-DP20VBK manual Catv/Dbs, Fm/Am, General

PROBLEM	POSSIBLE CAUSE		SOLUTION
Continuous hissing or buzzing during	Incoming signal is too weak.	Connect an outdoor FM antenna or contact
FM reception.		your dealer. (See page 7.)
	The station is too far away.	Select a new station.
	An incorrect antenna is used.	Check with your dealer to be sure you have
		the correct antenna.
	Antennas are not connected properly.	Check connections. (See page 7.)
Occasional cracking noise during FM	Ignition noise from automobiles.	Move the antenna farther from automobile
reception.		traffic.
Noise is heard during record playing.	A ground cable of the turntable is not	Connect it to the screw marked (H).
	connected to the screw marked (H).
Howling during record playing.	Your turntable is too close to speakers.	Move speakers away from the turntable.
“OVERLOAD” starts flashing on the	Speakers are overloaded because of high	1. Press	(STANDBY/ON) on the front
display.	volume either in Zone 1 or in Zone 2.	panel to turn off the receiver.
		2. Stop the playback source.
		3. Turn on the receiver again, and adjust the
		volume.
	Speakers are overloaded because of a short	Press	(STANDBY/ON) on the front
	circuit of the speaker terminals.	panel to turn off the receiver, check the
		speaker wiring, then press it again to turn on
		the receiver again. If “OVERLOAD” does
		not disappear despite speaker wiring not
		being short-circuited, consult your dealer.
The STANDBY lamp goes off after	Very high voltage or very low voltage is	Press	(STANDBY/ON) on the front
turning on the power, but soon the	applied to the unit, or built-in power	panel to turn off the receiver. After
receiver turns off again (into standby	amplifier becomes out of order.	unplugging the AC power cord, consult your
mode).		dealer.
Remote control does not work.	The ZONE 1/ZONE 2 selector is not set	Set the selector correctly either to “ZONE 1”
	correctly.	or to “ZONE 2.”
	The TV operation mode selector is not set	Set the selector correctly either to “TV” or to
	correctly.	“CATV/DBS.”
	The BAND 1/2 selectors on the rear and on	Set both the BAND 1/2 selectors to the same
	the remote control are set to a different band.	band. (See page 17.)
	RF communication between the receiver and	Consult your dealer.
	the remote control is interrupted from
	outside.
	Batteries are weak.	Replace batteries. (See page 18.)
Remote control does not work properly.	Incorrect remote control operation mode is	Select the correct remote control operation
	selected.	mode. (See pages 71 to 80.)

FM/AM

General

82