Weider 831.150380, PRO 335 Adjusting the Weider PRO, Attaching Weights to the Weight Carriage

Page 12

ADJUSTING THE WEIDER PRO 335

The weight bench is designed to be used with your own weight set (not included). The steps below explain how the weight bench can be adjusted. See EXERCISE GUIDELINES on page 14 for important exercise information and refer to the accompanying exercise poster to see the correct form for each exercise. Refer also to the exer- cise information accompanying your weight set for additional exercises.

Inspect and tighten all parts each time you use the weight bench. Replace any worn parts immediately. The weight bench can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents.

ATTACHING WEIGHTS TO THE WEIGHT CARRIAGE

To use the lat tower, first slide a Weight Stop (45) onto each side of the weight tube of the Weight Carriage (15). Slide the desired amount of weight (not included) onto the weight tube. Be sure that an equal amount of weight is on each side of the weight tube. Secure the weights on each side of the weight tube with a Spring Clip (29).

Do not place more than 150 pounds on the Weight Carriage. (Due to the fact that ab crunches are an aer- obic exercise, we recommend that you do not place more than 50 pounds on the Weight Carriage (15) while performing ab crunch exercises.)

ATTACHING WEIGHTS TO THE LEG LEVER

To use the Leg Lever (28), be sure there is a Weight Stop

(45)on the weight tube. Then slide the desired amount of weight (not included) onto the weight tube.

Do not place more than 150 pounds on the Leg Lever.

ADJUSTING THE BACKREST

The Backrest (36) can be set at three different positions: the level position, the decline position, and the incline posi- tion.

To change the position of the Backrest (36) to either the incline position or the level position, move the Adjustment Tube (37) to a different set of adjustment brackets on the Left and Right Uprights (42, 43). Set the Backrest (36) onto the Adjustment Tube.

To change the position of the Backrest (36) to the decline position, remove the Adjustment Tube (37). Set the Backrest (36) onto the Bench Frame (33).

 

Weight

 

45

45

29

 

29

15

 

 

Weight

 

Tube

Weight

 

 

28

 

Weight

 

45

 

Weight

 

Tube

36

43

 

37

 

Adjustment

 

Brackets

42

 

 

33

12

Image 12
Contents Patent Pending Model No Serial NoSEARS, Roebuck and CO., Hoffman ESTATES, IL Table of Contents Full 90 DAY WarrantyImportant Precautions Before YOU Begin Part Identification Chart Assembly Following Tools not Included are Required for AssemblyDo not tighten the Nylon Locknuts yet Page Same manner. The Barbell Lock Pins must be oriented as shown Tighten all M8 Nylon Locknuts 7 used in steps 1, 6,Backrests must be oriented as shown Locknut Page Adjusting the Weider PRO Attaching Weights to the Weight CarriageAttaching Weights to the LEG Lever Adjusting the BackrestPlace the same amount of weight on both ends of the barbell Storing the Weight BenchAttaching the LAT BAR to the High Pulley Station Locking the BarbellExercise Guidelines Cooling Down Staying MotivatedMuscle Chart Exercise Weight Sets Reps Aerobic Exercise Weight Sets RepsDate Part LIST-Model No Key Part Qty DescriptionExploded DRAWING-Model No QUESTIONS? Model No