Assembly, Do not tighten the Nylon Locknuts yet

ASSEMBLY

Before beginning assembly, carefully read the following information and instructions:

•Place all parts of the WEIDER® PRO 335 in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed.

•Read each assembly step before you begin.

•For help identifying the small parts used in assembly, use the PART IDENTIFICATION CHART on the previous page. Note: Some small parts may have been pre-attached for ship- ping purposes. If a part is not in the parts bag, check to see if it has been pre-attached.

•Tighten all parts as you assemble them, unless instructed to do otherwise.

•As you assemble the WEIDER® PRO 335, make sure that all parts are oriented as shown in the drawings.

THE FOLLOWING TOOLS (NOT INCLUDED) ARE REQUIRED FOR ASSEMBLY:

•Two (2) adjustable wrenches

•One (1) standard screwdriver

•One (1) rubber mallet

•Lubricant, such as grease or petroleum jelly, and soapy water will also be needed.

Assembly will be more convenient if you have the following tools: A socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches.

1.Before beginning assembly, be sure that you have read and understand the information in the box above.

Set the Left and Right Base Sections (40, 47) on the floor as shown. The indented holes must be facing the floor. Insert two M8 x 48mm Carriage Bolts (3) up through the indicated holes.

Press a 38mm x 50mm Inner Cap (16) into the Lower Lat Tower (23). Slide the Lower Lat Tower onto the two M8 x 48mm Carriage Bolts (3) in the Base (40, 47). Insert two M8 x 68mm Bolts (8) through the Lower Lat Tower and the Base. Thread M8 Nylon Locknuts (7) onto all four Bolts.

Do not tighten the Nylon Locknuts yet.

2.Press two 38mm x 50mm Inner Caps (16) into the Base (40). Insert four M8 x 48mm Carriage Bolts

(3) up through the Base.

1	23
	7
	8
		16
	7
	7	40
		40
	3
	47
	The Indented Holes
	must face the floor
2
		40
	3	16
	16
	3