Weider C670 user manual Is shown pulled away from the Center Upright for clarity

39.Locate the Long Cable (68). Route the eyelet end of the Cable through the Foot Plate (67) and the Center Upright (45), and under a Pulley (87).

Attach the Pulley (87) inside the Center Upright

(45)with an M10 x 75mm Bolt (92), two M10 Washers (35), two 17mm Spacers (89), and an M10 Nylon Locknut (34). Note: The Foot Plate

(67)is shown pulled away from the Center Upright for clarity.

40.Wrap the Long Cable (68) over a Pulley (87). Attach the Pulley to the Double “U”-bracket (81) with an M10 x 45mm Bolt (33) and an M10 Nylon Locknut (34).

41.Wrap the Long Cable (68) under a Pulley (87). Attach the Pulley to the Weight Guide Base (41) with an M10 x 45mm Bolt (33) and an M10 Nylon Locknut (34).

42.Wrap the Long Cable (68) over a Pulley (87). Attach the Pulley and a Cable Trap (88) to the second set of holes from the bottom of the Pulley Plates (82) with an M10 x 45mm Bolt (33) and an M10 Nylon Locknut (34). Make sure the Cable

Trap is oriented to hold the Cable in the groove of the Pulley.

43.Attach the Long Cable (68) inside the Weight Guide Base (41) with an M10 x 75mm Bolt (92), two M10 Washers (35), two 28mm Spacers (91), and an M10 Nylon Locknut (34).

44.Make sure that all parts are properly tightened before the weight bench is used. The use of all remaining parts will be explained in ADJUST- MENTS, beginning on the following page.

39
45
34	35
	89
87	89 35
67	92
68
40
34	81
	33
	87
	68
41
68
87
34
	41
	33
42
	82
	33
34	87
	88
	68
43
34
68
35
91
	41
	91
	35
	92

18