43.Wrap the Press Cable (72) around a 3 1/2" Pulley
(24)in the direction shown. Attach the Pulley and a Cable Trap (25) to the indicated hole on the far side of the Leg Press Lever (83) with a 3/8" x 4 3/4" Bolt
(60)and a 3/8" Nylon Jamnut (63). Note: Thread the
Jamnut only two tums onto the Bolt; you will later attach another Pulley to the Bolt. Make sure the Cable Trap is oriented as shown.
44.Wrap the Press Cable (72) around a
Large Cable Trap (32) underneath the Press Seat Frame (7) with a 3/8" x 4 1/4" Bolt (85), a 3/8" Flat Washer (48), and a 3/8" Nylon Locknut (50). Note: the Press Seat Frame has five adjustment holes. Mount the
Leg Press Lever. Make sure the Cable Trap is ori- ented as shown.
45.Wrap the Press Cable (72) around a 3 1/2" Pulley
(24)in the direction shown. Attach the Pulley and a Cable Trap (25) to the near side of the Leg Press Lever (83). Use the 3/8" x 4 3/4" Bolt (60) that was inserted in step 43 and secure the Pulley with the 3/8" Nylon Jamnut (63). Make sure the Cable Trap is oriented as shown.
46.Wrap the Press Cable (72) around a 3 1/2" Pulley
(24)in the direction shown. Attach the Pulley and a Cable Trap (25) to near side of the Press Upright (2). Use the 3/8" x 4 3/4" Bolt (60) that was inserted in
step 42 and secure the Pulley with the 3/8" Nylon
Jamnut (63). Make sure the Cable Trap is oriented as shown.
Wrap the Press Cable (72) around a 3 1/2" Pulley
(24)in the direction shown. Attach the Pulley and a
Cable Trap (25) to the 3/8" x 4" Carriage Bolt (102) that was inserted into the Press Base (6) earlier. Secure the Pulley with the 3/8" Nylon Locknut(50). Make sure the Cable Trap is oriented as shown.
2
25
72
45
60_
25/
72
63
46 " | ' | 50 242 |
18