Weider 831.15973 user manual At the end of the Ab re-attachthe =U

Page 27

The threaded ends on the Press Cable (72) and the Ab

Cable (74) that are attached to the weight stacks can also be used to tighten the cables.

To tighten the Ab Cable (74), remove the =U"-Bracket(97) from the Short Weight Tube (17) by removingthe 5/16" x 1 3/4" Bolt (96) and the 5/16" Nylon Locknut (64).

Tighten the 1/4" Nylon Locknut (68) Cable (74) as far as it will go. Then

Bracket (97).

at the end of the Ab re-attachthe =U"-

The Press Cable (72) can be tightened the same way.

When you are tighteningthe cables, take note that they are linked into two distinctgroups. The Butterfly Cable (73), the Ab Cable (74), and the Low Pulley Cable (75) are all connected to the small weight stack. All three cables will be tightened by tightening the Ab Cable (74) as described above or by using the Adjustable Pulley Plates (23) as described on the previouspage.

The Press Cable (72) is the only cable attached to the large weight stack. It must be tightened by using the method described above or by moving the "V"-Pulleysas described on the previous page.

The chart below shows the approximate weight resistance at each exercise station. "Top" refers to the 6 lb. top weight; the other numbers refer to the 12.5 lb. weight plates. Note: The actual resistance at each station may vary due to differences in individual weight plates as well as friction between the cables, pulleys, and weight guides.

152226288

27

Image 27
Contents 800-72,6-6879 Back Cover Arms Four Stages of the Assembly Process Assembly 84 u Page Page 46 ,. ¢U-o=.50 Assembly LOj Direction shown. Attach the Pulley to 74 a Page Page Page Page Page Page Locate and open the parts bag labeled Seat 43 30 Tube Do notallowchildren onor around machine Replacelabelif 72, 389.5 c Press Cable 711 Page Page At the end of the Ab re-attachthe =U 1RetainerRing31 \\\\\\\l Key No. Qty Descdptlon 6450 Sears