52. Insert a 1/4" x 2 112"Carriage Bolt (45) through the | 52 |
center hole in a Seat Plate (65). Attach the Seat Plate to a Seat (13) with two 1/4" x 3/4" Bolts (49),
Insert the 1/4" x 2 1/2" Carriage Bolt (45) into the indi- cated hole in the ButterflySeat Frame (14) end secure it with a 1/4" Flat Washer (71) and a 1/4" Nylon Locknut (68). Secure the other end of the Seat
(13)with a 1/4" x 2 1/2" Bolt (79) and a 1/4" Flat Washer (71).
Attach the other Seat (13) to the Press Seat Frame (7, not shown) in the same manner.
53.Press 3/4" Round Inner Caps (43) into the ends of the
Pad Tube (42) and the indicatedtube on the Front Leg (20),
Insert the Pad Tube (42) intothe indicated hole in the
Small Leg Lever (41). Slide Foam Pads (30) onto the ends of the Pad Tube and the tube on the Leg Lever.
54.Press a 1 3/4" Square Inner Cap (35) into the indicat- ed end of the Adjustment Tube (90).
Attach the Adjustment Tube (90) to the bracket (not visible in the drawing) on the back of the Leg Press Plate (55) with a 5/16" x 2 1/2" Bolt (87), two 5/16"
Washers (36), and a 5/16" Nylon Locknut (64).
Attach the Leg Press Plate (55) to the Leg Press Lever (83) by placing the AdjustmentTube (90) into the bracket on top of the Leg Press Lever and secur- ing it with the Lock Pin (91). Note: The lip on the Leg Press Plate must be on the upper edge.
55.Attach the Curl Pad (105) to the Cud Post (104) with two 1/4" x 3/4" Bolts (49),
53
43 30 Tube
30
54
35
55
55
21