Weider 831.15973 user manual

Page 19

47.Route the threaded end of the Press Cable (72) around the 3 1/2" Pulley (24) that was mounted on the bracket on the Weight Base (5) in an earlier step.

48.Wrap the Press Cable (72) over a 4 1/2" Pulley (82) in the direction shown. Attach the Pulley inside the indicated bracket on the Weight Top Frame (66) with

a 3/8" x 1 3/4" Bolt (57) and a 3/8" Nylon Locknut (50). Make sure the end of the Cable is routed

through the bracket, as shown.

49.Attach the threaded end of the Press Cable (72) to the remaining =U"-Bracket(97) with a 1/4" Flat

Washer (71) and a 114"Nylon Locknut (68).

Attach the =U"-Bracket(97) to the hole in the Long

Weight Tube (70) with a 5/16" x 1 3/4" Bolt (96) and a 5/16" Nylon Locknut (64). Note: Do not completely tighten the Nylon Locknut; it should be threaded only two turns onto the end of the Cable, as shown in the inset drawing.

Important: Follow all four cables from end to end and make sure that they rest in the grooves of all pulleys and that the cables and the pulleys move smoothly.

47

48

50 82

68

72

19

Image 19
Contents 800-72,6-6879 Back Cover Arms Four Stages of the Assembly Process Assembly 84 u Page Page 46 ,. ¢U-o=.50 Assembly LOj Direction shown. Attach the Pulley to 74 a Page Page Page Page Page Page Locate and open the parts bag labeled Seat 43 30 Tube Do notallowchildren onor around machine Replacelabelif 72, 389.5 c Press Cable 711 Page Page At the end of the Ab re-attachthe =U 1RetainerRing31 \\\\\\\l Key No. Qty Descdptlon 6450 Sears