Weider 831.15973 guide

28.Wrap the Ab Cable (74) around a 3 1/2" Pulley (24) in the direction shown. Slide the Pulley and a Cable Trap (25) onto the 3/8" x 3 1/2" Carriage Bolt (95) already inserted into the Butterfly Base (4). Secure

the Pulley with a 3/8" Nylon Jamnut (63). Make sure the Cable Trap is oriented as shown.

Route the threaded end of the Ab Cable (74) under

the 3 1/2" Pulley (24) that is already mounted on the Weight Base (5). Make sure the Cable is routed in the direction shown.

Note: For clarity, this and the following drawings show some parts removed.

29.Wrap the h,b Cable (74) around a 4 1/2" Pulley (82) in the direction shown. Attach the Pulley inside the indi- cated bracket on the Weight Top Frame (66) with a 3/8" x 1 3/4" Bolt (57) and a 3/8" Nylon Locknut (50). Make sure the threaded end of the Ab Cable is routed through the bracket, as shown.

30.Attach the threaded end of the Ab Cable (74) to a =U'- Bracket (97) with a 1/4" Flat Washer (71) and a 1/4" Nylon Locknut (68).

Attach the "U"-Bracket(97) to the hole in the Short Weight Tube (17) with a 5/16" x 1 3/4" Bolt (96) and a 5/16" Nylon Locknut (64). Note: Do not completely tighten the Nylon Locknut; it should be threaded only two turns onto the end of the Cable, as shown in the inset drawing.

I 24 74

/66