9.Press a 2" Square Inner Cap (28) into the Press Seat
Frame (7). | 36 |
|
Slide the bracket on the Press Seat Frame (7) onto the indicated 5/16" x 2 1/2" Carriage Bolts (92) in the Press Base (6). Hand tighten two 5/16" Nylon Locknuts (64) onto the Bolts. Do not tighten the Nylon Locknuts yet.
Attach the Press Seat Frame (7) to the Press Upright
(2)with two 5/16" x 2 3/4" Bolts(89), two 5/16" Washers (36), and two 5/16" Nylon Locknuts (64). Do not tighten the Nylon Locknuts yet.
10.Lubricatethe 3/8" x 3" Bolt (88). Attach the Leg Press Lever (83) to the Press Base (6) with the Boltand a 3/8" Nylon Locknut (50). Do not overtighten the Nylon Locknut; the Leg Press Lever must pivot easily.
11.Place two Weight Bumpers (51) over the indicated holes in the Weight Base (5). Slide a Weight Guide
(15)into each of the holes.
Attach the indicatedWeight Guide (15) to the Weight
Base (5) with a 3/8" x 2 3/4" Bolt (46), two 3/8" Flat
Washers (48), and a 3/8" Nylon Locknut (50).
Slide six Weights (21) onto the Weight Guides (15).
Make sure the Weights are turned so the pin grooves point towards the floor.
Press a Weight Tube Bumper (18) intothe lower end of the Short Weight Tube (17). Slide the Weight Tube into the center holes in the Weights (21).
Slide a Top Weight (16) onto the Weight Guides (15). Note: Make sure the Top Weight is turned so the groove fits over the welded pin on the Weight Tube (17).
8