Weider 831.159530 Pulley make sure that the large tabs are, Cable Trap is oriented as shown

41. Identify the Ab Cable (83); it is approximately	41
220.25” long and it has a ball on one end and a
loop on the other.	91	75				Large tabs
						must be on
Wrap the Ab Cable (83) around a 3 1/2” Pulley
					49	this side
(37). Place two Pulley Covers (49) over the					37
Pulley; make sure that the large tabs are in the	Rod
position shown. Attach the Pulley and Pulley
Covers to the Butterfly Upright (4) with a 3/8” x 4”
Bolt (91), two 3/8” Washers (75), and a 3/8” Nylon			Ball	83	75
Locknut (74). Be sure that the Cable is between						74
	4			49
the Pulley and the rod on the Upright, and that
the ball is on the side shown.
42. Remove the two 3 1/2” Pulleys (37) from the	42
Double U-bracket (42). Wrap the Ab Cable (83)
around a Pulley. Reattach the Pulley to the	83
Double U-bracket with the 3/8” x 2” Bolt (79) and
3/8” Nylon Locknut (74).
	37
	74
	42		79
43. Wrap the Ab Cable (83) around the other 3 1/2”	43
Pulley (37) removed in step 38. Reattach the
Pulley and Cable Trap (44) to the bottom set of
holes in the Pulley Plates (43) with the 3/8” x 2”				43
Bolt (79) and the 3/8” Nylon Locknut (74). Be
sure the Cable Trap is turned to hold the		79			74
Cable in the groove of the Pulley.
					44
		83		37
44. Wrap the Ab Cable (83) around a 3 1/2” Pulley	44
(37). Attach the Pulley and a Cable Trap (44) to
the Butterfly Base (1) with a 3/8” x 1 3/4” Bolt	83
(103) and a 3/8” Nylon Jamnut (88). Make sure	103
the Cable Trap is oriented as shown.
		44	1
	37
			88
	17