4.Press a 1 1/2” Square Inner Cap (100) into the indicated part of the Press Upright (6).
Orient the Press Upright (6) as shown. Attach the Press Upright to the indicated 5/16” x 2 1/2” Carriage Bolts (54) in the Press Base (3) with two 5/16” Nylon Locknuts (64).
Attach the Support Brace (7) to the indicated 3/8” x 2 1/2” Carriage Bolts (76) in the Press Base (3) with two 3/8” Nylon Locknuts (74).
Attach the Support Brace (7) to the Press Upright
(6)with two 5/16” x 2 1/2” Carriage Bolts (54) and two 5/16” Nylon Locknuts (64).
Do not tighten the Nylon Locknuts (64, 74) yet.
5.Press two 1” Inner Caps (32) into the ends of the weight tube on a Weight Carriage (28).
If you will be using Olympic weights with the weight system, slide a Weight Sleeve (27) onto each end of the weight tube on the Weight Carriage (28). Secure each Weight Sleeve with a Locking Pin (31). Note: The drawings in this manual show the Weight Sleeves attached. The Locking Pins will be found in the bag labled “SEAT ASSEMBLY”.
Repeat this step with the other Weight Carriage (28).
6.Press a Weight Bumper (56) onto each bumper tube on the Center Base (2). Press a 1 1/2” Round Inner Cap (67) into each bumper tube.
Attach two Weight Guides (33) to the indicated tube in the Center Base (2) with a 3/8” x 6” Bolt (89) and a 3/8” Nylon Locknut (74).
Attach the other set of Weight Guides (33) in the same manner.
Do not tighten the 3/8” Nylon Locknuts (74) yet.
4 |
|
|
|
|
| 100 |
|
|
|
| 64 |
|
| 54 | 7 |
|
| 64 | |
|
| 6 |
|
|
|
| 74 |
|
|
| 74 |
|
|
| 64 |
|
| 64 |
|
|
|
| 76 |
| 3 |
| 54 |
|
|
| |
5 |
| 27 |
|
|
|
| |
| 32 |
| 31 |
|
|
| 28 |
| Weight Tube | 27 | |
|
|
| |
|
|
| 31 |
6 |
|
|
|
|
| 33 |
|
|
| 33 |
|
| 67 | 56 |
|
|
|
| |
|
| 74 |
|
|
| 67 |
|
|
| 2 | 56 |
|
|
| |
89 | Tube | Bumper |
|
|
| ||
|
| Tube |
|
7