Weider 831.159530 user manual

56. Press a 1 1/2” Square Inner Cap (100) into the	56
back of the Backrest Bracket (21). Press two 1” x
			98
2” Inner Caps (70) into the top and bottom of the
		70
Backrest Bracket.
Insert a 1/4” x 1 3/4” Carriage Bolt (93) into the			84
		21
center hole of a Support Plate (57). Attach the			100
Support Plate to Press Backrest (20) with two
1/4” x 3/4” Screws (90). Attach the Backrest to		90	106	51
the Backrest Bracket (21) with the Carriage Bolt,		57
	20
a 1/4” Washer (84), and a 1/4” Nylon Locknut
			84
(106). Attach the top of the Backrest to the				6
Backrest Bracket with 1/4” x 1 3/4” Screw (98)			90
and a 1/4” Washer (84).		93
Loosen the Adjustment Knob (51) by turning it		70
counterclockwise, and pull it out as far as possi-
ble. Insert the Backrest Bracket (21) into the
Press Upright (6) and align an adjustment hole
with the the Adjustment Knob. Snap the Knob into
the adjustment hole and turn it clockwise until	57
tight.
57. Press a 1 3/4” Square Inner Cap (60) into the		46
			23	60
back of the Adjustment Tube (23).
		66
Attach the Adjustment Tube (23) to the Press		64
Plate (24) with a 5/16” x 2 1/2” Bolt (63), two
5/16” Washers (66), and a 5/16” Nylon Locknut
(64).			66
			63
Attach the Adjustment Tube (23) to the Leg Press
Arm (22) with the Press Pin (46).		24
			22
58. Press four 3/4” Round Inner Caps (73) into the	58
ends of the Long and Short Pad Tube (39, 40).
	73
		41
Insert the Long Pad Tube (39) into the welded
tube on the Butterfly Front Leg (9). Slide two
Foam Pads (41) onto the ends of the Pad Tube.		Welded
	73
Insert the Short Pad Tube (40) into the hole in the		Tube
Leg Lever (8). Slide two Foam Pads (41) onto the		39
ends of the Pad Tube
				41
	41
		8
				73
		40
		9
			41	73

21