Frame Assembly
1.Before beginning, make sure that you have read and understood the information on page 5.
Locate and open the parts bags labeled “FRAME ASSEMBLY 1 and 2.”
Press a 2” Square Inner Cap (59) into each end of the Butterfly Base (1).
Insert four 5/16” x 2 1/2” Carriage Bolts (54) up through the Butterfly Base (1). Place the Butterfly Base flat on the floor. Note: If the Bolts fall out, secure them with a small piece of tape.
Attach the Center Base (2) to the Butterfly Base
(1)with two 5/16” x 2 3/4” Bolts (55), a Long Support Plate (34), and two 5/16” Nylon Locknuts
(64).Do not tighten the Nylon Locknuts yet.
2.Press a 2” Square Inner Cap (59) into each end of the Press Base (3).
Insert four 5/16” x 2 1/2” Carriage Bolts (54) and two 3/8” x 2 1/2” Carriage Bolts (76) up through the Press Base (3). Place the Press Base flat on the floor. Note: If the Bolts fall out, secure them with a small piece of tape.
Attach the Press Base (3) to the Center Base (2) with two 5/16” x 2 3/4” Bolts (55), a Long Support Plate (34), and two 5/16” Nylon Locknuts (64). Do not tighten the Nylon Locknuts yet.
3.Orient the Butterfly Upright (4) as shown. Attach the Butterfly Upright to the indicated 5/16” x 2 1/2” Carriage Bolts (54) in the Butterfly Base (1) with two 5/16” Nylon Locknuts (64). Do not tight- en the Nylon Locknuts yet.
6
1 |
| 59 |
55 | 34 | |
|
| 64 |
1 |
|
|
| 64 | 2 |
| 54 | |
|
| |
54 |
|
|
59 |
|
|
2 |
|
|
2 | 64 | 59 |
| ||
|
| |
64 |
| 34 |
3 | 76 | 55 |
| ||
59 | 54 |
|
54 |
|
|
3 |
|
|
| 4 |
|
| 64 |
|
64 |
|
|
| 54 |
|
1 |
|
|