Weider WESY29510 instruction

17.Route the Long Cable (41) around a “V”-Pulley

(46).Attach the Pulley and a Long Cable Trap

(43)to the bracket on the Left Arm (11) with a 3/8” x 2 1/2” Bolt (79) and a 3/8” Nylon Locknut (84).

Be sure that the Cable is in the groove of the Pulley and that the Cable Trap is positioned to hold the Cable in place.

18.Route the Long Cable (41) around a “V”-Pulley

(46).Attach the Pulley and a Long Cable Trap

(43)to the bracket on the Right Arm (12) with a 3/8” x 2 1/2” Bolt (79) and a 3/8” Nylon Locknut

(84).Be sure that the Cable is in the groove of the Pulley and that the Cable Trap is posi- tioned to hold the Cable in place.

19.Route the Long Cable (41) around the 3 1/2” Pulley (45) attached to the Pulley Bracket (51).

Be sure that the Cable is in the groove of the Pulley and that the Cable Trap (44) is turned to hold the Cable in place. Tighten the 3/8” Nylon Locknut (84).

Be sure that the 5/16” x 5” Bolt (not shown) is properly tightened and that the Pulley Bracket (51) can move freely.

20.Attach a 3 1/2” Pulley (45) and a Cable Trap (44) to the indicated hole in the Long “U”-Bracket (50) with a 3/8” x 2” Bolt (74) and a 3/8” Nylon Locknut (84). Be sure that the Cable Trap is inside the “U”-Bracket. Note: This may come pre-assembled.

Route the Long Cable (41) between the 3 1/2” Pulley (45) and the Cable Trap (44). Be sure that the Cable is in the groove of the Pulley and that the Cable and Pulley move smoothly.

17
	79
43
46
Bracket
41
84		11
84
18
79
43
46
Bracket
12
41
84
19		51
		51
41	45	44
84
20
41
45
44
74
	50	84
		84