Seat Assembly
28.Attach the Backrest (21) to the Front Upright (4) with two 1/4” x 2 1/2” Screws (72) and two 1/4” Washers (81).
29.Press a 1 1/2” Square Inner Cap (57) into the Seat Frame (15).
Insert the 1/4” x 2” Carriage Bolt (68) into the center hole in the Seat Plate (19). Attach the Seat Plate to the Seat (20) with two 1/4” x 3/4” Screws
Insert the 1/4” x 2” Carriage Bolt (68) into the indi- cated hole in the Seat Frame (15). Tighten a 1/4” Nylon Locknut (82) with a 1/4” Washer (81) onto the Carriage Bolt.
Attach the other end of the Seat (20) to the Seat Frame (15) with a 1/4” Washer (81) and the 1/4” x 2” Screw (76).
30.Press a 1 1/2” Square Inner Cap (57) into the Leg Lever (16).
Lubricate the 5/16” x 2 1/4” Bolt (77). Attach the Leg Lever (16) to the Seat Frame (15) with the Bolt and a 5/16” Nylon Locknut (83). Do not overtighten the Nylon Locknut; the Leg Lever must be able to pivot freely.
Insert a 3/8” x 2” Eyebolt (64) into the Leg Lever
(16)from the direction shown. Tighten a 3/8” Nylon Locknut (84) and a 3/8” Washer (86) onto the Eyebolt.
31.Rest the Seat Frame (15) on the indicated pin in the Front Upright (4). Attach the Seat Frame to the Front Upright with a 5/16” x 2 3/4” Carriage Bolt (66) and the Seat Knob (60).
14
28 |
| 4 |
|
| |
| 21 |
|
|
| 72 |
|
| 81 |
|
| 72 |
|
| 81 |
29 |
|
|
|
| 20 |
|
| 68 |
|
| 19 |
| 57 | 67 |
|
| |
|
| 15 |
|
| 82 |
| 76 | 81 |
|
| |
30 |
|
|
| 15 |
|
| 83 | Lubricate |
|
| |
| 16 | 77 |
|
| |
| 86 | 64 |
|
| |
| 84 | 57 |
|
| |
31 |
| 66 |
|
| |
|
| 15 |
|
| 60 |
|
| Pin |
|
| 4 |