3.Slide the nine Weights (22) onto the Weight Guides (9). Be sure that all of the Weights are turned so the large pin grooves are on the bottom of the Weights and on the front of the weight stack.
Press the Weight Tube Bumper (27) into the end of the Weight Tube (26). Insert the Weight Tube into the stack of Weights (22). Be sure that the pins on the Weight Tube are resting in the pin grooves in the upper Weight.
Lubricate the insides of the holes in the Top Weight (24). Slide the Top Weight onto the Weight Guides (9).
4.Press a 1” Square Inner Cap (53) into the Front Upright (4).
Slide the Front Upright (4) onto the 5/16” x 2 1/2” Carriage Bolts (65) in the Base (2). Hand tighten two 5/16” Nylon Locknuts (83) onto the Carriage Bolts. Do not tighten the Nylon Locknuts yet.
5.Press two 2” Square Inner Caps (55) into the ends of the Top Frame (10). Press a 1 3/4” Square Inner Cap (56) into each end of the cross- bar on the Top Frame. Press two Round Inner Caps (59) into the top of the crossbar.
Attach the Top Frame (10) to the Front Upright (4) and the Rear Upright (5) with four 5/16” x
2 3/4” Bolts (73), four 5/16” Washers (85), and four 5/16” Nylon Locknuts (83).
Tighten the 5/16” Nylon Locknuts (83) used in steps 4 and 5.
3 |
|
|
|
|
|
| 9 |
|
|
| Lubricate |
| 24 | |
|
|
| ||
|
| Pin |
|
|
|
| 26 |
|
|
|
| 27 |
|
|
|
| Pin |
|
|
| Groove |
|
| |
|
|
|
| 22 |
4 |
|
|
|
|
|
| 4 |
|
|
| 53 |
|
|
|
| 83 |
|
|
|
| 65 |
|
| |
|
| 2 |
|
|
5 |
|
| 73 | 85 |
|
| 73 | 85 | |
|
|
| ||
|
| 85 |
|
|
| 56 | 59 |
| 55 |
|
|
|
| |
|
|
|
| 10 |
|
|
| 56 |
|
55 | Crossbar |
|
| |
|
| 83 | ||
|
|
|
| |
|
| 83 |
| 5 |
|
| 4 |
| |
|
|
|
| |
7