ADJUSTMENTS
The instructions below describe how each part of the weight system can be adjusted. Refer to the exercise guide accompanying this manual to see how the weight system should be set up for each exercise. IMPOR-
TANT: When attaching the lat bar or nylon strap, make sure that the attachments are in the correct start- ing position for the exercise to be performed. If there is any slack in the cables or chain as an exercise is performed, the effectiveness of the exercise will be reduced.
CHANGING THE WEIGHT SETTING
To change the weight setting of the weight stack, insert the Weight Pin (23) under the desired Weight (22). Be sure to insert the Weight Pin until the bent end of the Weight Pin is touching the Weights, and turn the bent end downward. The weight setting of the weight stack can be changed from 6.5 pounds to 119 pounds, in increments of 12.5 pounds. Note: Due to the cables and pulleys, the actual amount of resistance at each exercise station may vary from the weight setting. Use the WEIGHT RESISTANCE CHART on page 19 to find the actual amount of resistance at each weight station.
ATTACHING THE LAT BAR OR NYLON STRAP TO THE HIGH OR LOW PULLEY STATION
Attach the Lat Bar (34) to the Long Cable (41) or Short Cable (not shown) with a Cable Clip (38). For some exercises, the Chain (37) should be attached between the Lat Bar and the Cable with two Cable Clips.
Adjust the length of the Chain between the Lat Bar and the Cable so the Lat Bar is in the correct start- ing position for the exercise to be performed.
Note: The seat frame must be removed from the front upright before the Short Cable (not shown) is used. (See ATTACHING AND REMOVING THE SEAT, below.)
The Nylon Strap (not shown) can be attached in the same manner.
ATTACHING AND REMOVING THE SEAT
Set the bracket on the Seat Frame (15) onto the indi- cated pin on the Front Upright (4). Attach the Seat Frame to the Front Upright with the 5/16” x 2 3/4” Carriage Bolt (66) and the Seat Knob (60).
For some exercises, the Seat (20) must be removed. First, be sure that the Chain (not shown) is not attached to the Leg Lever (16). Next, remove the Seat Knob (60) and the 5/16” x 2 3/4” Carriage Bolt
(66)from the Seat Frame (15). Lift the Seat Frame off the Front Upright (4).
| 23 | 22 |
| 37 |
|
|
| 41 |
|
| 38 |
34 | 38 |
|
|
| |
| 15 |
|
| 66 | 13 |
20 | 60 | |
|
| |
| 4 |
|
16 |
|
|
|
| Pin |
17 |
|
|