Weider WEBE37340 user manual Locknuts yet

Page 10

9.Attach the Foot Plate (67) and the Weight Guide Base (41) to the Center Base (39) with two M10 x 81mm Button Bolts (104) and two M10 Nylon Locknuts (34). Do not tighten the Locknuts yet.

10.Attach the Center Top Frame (46) to the Left Top Frame (48) with two M10 x 78mm Bolts (32) and two M10 Nylon Locknuts (34). Make sure the decal is in the indicated location. Do not tight- en the Locknuts yet.

Attach the Center Top Frame (46) to the Right Top Frame (47) with two M10 x 78mm Bolts (32) and two M10 Nylon Locknuts (34). Do not tight- en the Locknuts yet.

11.Slide the Weight Carriage Stop (65) onto the Weight Guide Upright (42) as shown, and attach it at the indicated hole with an M10 x 87mm Bolt (106) and an M10 Nylon Locknut (34).

Attach the Weight Guide Upright (42) to the Weight Guide Base (41) with two M10 x 75mm Bolts (92), four M10 Washers (35), and two M10 Nylon Locknuts (34). Do not tighten the

Locknuts yet.

9
		34
		41
67		34
67
		39
104
10
34
		46
47
		Decal
32		34
		32
		48
11
	42
34	35
		Hole
34		35
34	35
		92
		Hole closer
65		to bottom
		106
		41

10

Image 10

Contents Model No. WEBE37340 Serial No QUESTIONS?Customer HOT Line Table of Contents Misuse of this product may result in serious injury DecalImportant Precautions Right Side Before YOU BeginLeft Side Make Things Easier for Yourself AssemblyLocknuts yet Repeat this step with the Right Base not Shown Holes Page Tighten the Locknuts yet Locknuts yet Tighten the M10 Nylon Locknuts 34 used Steps Caps 80. Do not overtighten the Locknut Locate the Medium Cable 69. Route the CablePage Locate the Butterfly Cable 31. Lubricate an Cooling Down Muscle ChartStaying Motivated Exercise Guidelines Is shown pulled away from the Center Upright for clarity Do not tighten the Locknuts yet Bracket Frames must be able to pivot easily Tighten the M10 Nylon Locknuts 34 used in stepsAssemble two Pad Tubes 27 to the Leg Lever Same manner Page Adjusting the Backrest AdjustmentsAdding Weight to the Weight Carriage or Barbell Attaching the Accessories Adding Weight to the LEG LeverAttaching the LEG Lever or Curl PAD Tightening the Cables Using the Weight Rests and Safety SpottersSetting UP for Squat Exercises Knobs 22 are fully tightenedButterfly Cable Cable DiagramsOr bind the cables Medium Cable Long CableAerobic Exercise Exercise Weight Sets RepsDate Thursday Aerobic Exercise DateMonday Part Identification CHART-Model No. WEBE37340 R0704A M10 x 68mm Bolt Part LIST-Model No. WEBE37340 Qty DescriptionExploded DRAWING-Model No. WEBE37340 R0704A Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT