Weider WEBE37340 user manual Assemble two Pad Tubes 27 to the Leg Lever Same manner

Page 20

38.Attach the Seat (10) to the Bench Frame (1) as shown with four M6 x 16mm Screws (29).

39.Attach the Weight Tube (76) to the Leg Lever (5) with an M8 x 58mm Bolt (75), two M8 Washers (60), the 10mm Spacer (21), and an M8 Nylon Locknut (17).

Press the 19mm Angled Outer Cap (61) onto the indicated end of the Weight Tube (76).

40.Lubricate an M10 x 68mm Bolt (98) with grease. Attach the Leg Lever (5) to the Bench Leg (4) with the Bolt and an M10 Nylon Locknut (34). Do not overtighten the Locknut; the Leg Lever must be able to pivot easily.

41.Slide a Pad Tube (27) into the Bench Leg (4). Slide two Foam Pads (26) onto the ends of the Pad Tube.

Assemble two Pad Tubes (27) to the Leg Lever

(5) in the same manner.

38
10
				1
				29
		29
39
		5
			60	61
			60
		75 21		17
				17
	76			60
				60
40			4
	5	34	4
		34

				98
41
26		27		4
26

		5
		27		27
		27		26
				26

18

Image 20

Contents Customer HOT Line QUESTIONS?Model No. WEBE37340 Serial No Table of Contents Misuse of this product may result in serious injury DecalImportant Precautions Left Side Before YOU BeginRight Side Locknuts yet Repeat this step with the Right Base not Shown AssemblyMake Things Easier for Yourself Holes Page Tighten the Locknuts yet Locknuts yet Tighten the M10 Nylon Locknuts 34 used Steps Caps 80. Do not overtighten the Locknut Locate the Medium Cable 69. Route the CablePage Locate the Butterfly Cable 31. Lubricate an Staying Motivated Muscle ChartCooling Down Exercise Guidelines Is shown pulled away from the Center Upright for clarity Do not tighten the Locknuts yet Bracket Frames must be able to pivot easily Tighten the M10 Nylon Locknuts 34 used in stepsAssemble two Pad Tubes 27 to the Leg Lever Same manner Page Adding Weight to the Weight Carriage or Barbell AdjustmentsAdjusting the Backrest Attaching the LEG Lever or Curl PAD Adding Weight to the LEG LeverAttaching the Accessories Using the Weight Rests and Safety Spotters Setting UP for Squat ExercisesTightening the Cables Knobs 22 are fully tightenedCable Diagrams Or bind the cables Medium CableButterfly Cable Long CableExercise Weight Sets Reps DateAerobic Exercise Thursday Aerobic Exercise DateMonday Part Identification CHART-Model No. WEBE37340 R0704A M10 x 68mm Bolt Part LIST-Model No. WEBE37340 Qty DescriptionExploded DRAWING-Model No. WEBE37340 R0704A Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty