English
Using the Timers
There are three timers
•Before using the timers, set the clock built in the unit. (See page 9.)
Using Daily Timer
With Daily Timer, you can wake up to your favorite music or radio program.
• You can set the timers whether the unit is on or off.
How Daily Timer actually works
The unit automatically turns on, sets the volume level to the preset level, and starts playing the specified source when the
The Daily Timer works everyday automatically. If you do not want to use the Daily Timer, turn it off. (See “To turn on or off Daily Timer after it has been set” on page 24.) The timer setting remains in memory until you change it.
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
•To correct a misentry while setting the timer, press
CANCEL/DEMO.
On the unit ONLY:
1 Press CLOCK/TIMER repeatedly
until “DAILY” appears on the | CLOCK |
/TIMER | |
display. |
|
The (Timer) indicator lights up and the DAILY (Daily Timer) indicator also starts flashing on the display.
•Each time you press the button, the timer setting modes change as follows:
DAILY TIMER REC
(Daily Timer setting)
Canceled |
| Clock |
|
| TIMER |
|
| ||||
|
| setting | (Recording Timer setting) |
(The hour digits start flashing.)
2 Press CLOCK/TIMER again.
“TIMER” appears for about 2 seconds, then | CLOCK |
the unit enters | /TIMER |
|
3 Set the on-time you want the unit to turn on at.
Before you start...
• When using a disc as the source to play: |
– Make sure there is a disc on the selected disc tray. |
• When using a tape as the source to play: |
– Make sure that a tape is in the cassette deck. |
1)Turn ¢/ 4to set the hour, then press SET/DISPLAY.
2)Turn ¢/ 4to set the minute, then press SET/DISPLAY. “SET” appears for about 1 second, then the unit enters off- time setting mode.
PR
ES
E
T
– Make sure that the tape direction is correct. |
• When using an external component as the source to |
play: |
– Set the timer equipped on the external component to |
the same time. |
SET
/DISPLAY
4 Set the off-time you want the unit to turn off (standby) at.
1)Turn ¢/ 4to set the hour, then press
SET/DISPLAY.
2)Turn ¢/ 4to set the minute, then press
SET/DISPLAY.
“SET” appears for about 1 second, then the unit enters source selecting mode.
23