JVC CA-HXZ30, CA-HXZ10 manual Connecting Other Equipment, Canceling the Demonstration

Page 13

Connecting Other Equipment

You can connect an external audio component used only as a playback device.

DO NOT connect any equipment while the power is on.

DO NOT plug in any equipment until all connections are complete.

To connect an external audio component

Be sure that the plugs of the audio cords are colored: White plugs and jacks are for left audio signals, and red ones for right audio signals.

English

Now, you can plug the AC power cord.

If the wall outlet does not match the AC plug, use the supplied AC plug adaptor.

IMPORTANT: Be sure to check that all connections are done before plugging the AC power cord into a wall outlet.

Canceling the Demonstration

When connecting the AC power cord to a wall outlet, the unit automatically starts demonstration.

To play external audio component through this unit,

connect between the audio output jacks on the other equipment and AUX jacks by using an audio cord (not supplied).

To cancel the demonstration, press and hold CANCEL/DEMO until “DEMO OFF” appears on the display.

• To cancel only beep sounds during the demonstration, press and hold BEEP for more than 2 seconds or press BEEP ON/OFF on the remote control.

The BEEP ON indicator goes off from the display.

When you press other buttons

CANCEL

/DEMO

 

 

 

 

T

 

 

 

 

U

 

 

 

 

N

/BEEP

 

I

 

N

 

 

 

 

G

 

 

 

 

 

BEEP

ON/OFF

FADE

MUTING

Audio equipment

To audio output

Adjusting the Voltage Selector

Before plugging in the unit, set the correct voltage for your area with the voltage selector on the rear of the unit.

Voltage mark

Use a screwdriver to rotate the voltage selector so that the voltage mark is pointing at the same voltage as where you are plugging in the unit. (See the back cover page.)

DO NOT plug in before setting the voltage selector on the rear of the unit and all connection procedures are complete.

The demonstration stops temporarily. It will start automatically again (if no operation is done for 2 minutes) unless you cancel it by pressing CANCEL/DEMO.

To start demonstration manually

Press and hold CANCEL/DEMO again until “DEMO START” appears on the display.

8

Image 13
Contents CA-HXZ30 CA-HXZ10 Precaución--botón en espera/encendido Precaución CA-HXZ30 CA-HXZ10 Produto Laser Classe Introduction PrecautionsAbout This Manual Contents Front Panel Location of the Buttons and ControlsFront Panel ROCK, POP, Classic Display WindowRemote Control Remote ControlConnecting Antennas Supplied AccessoriesGetting Started AM antenna Connecting SpeakersTo connect an outdoor AM antenna Close the speaker terminalsCanceling the Demonstration Connecting Other EquipmentAdjusting the Voltage Selector To connect an external audio componentSetting the Clock Turning On or Off the PowerCommon Operations Selecting the SourcesSelecting the Sound Modes Adjusting the VolumeReinforcing the Bass Sound To use your own sound mode Creating Your Own Sound Mode-User ModeTurning On or Off the Key-touch Tone Presetting Stations Setting the AM Tuner Interval SpacingTuning in to a Station Tuning in to a Preset StationDisc Play Introduction When playing a CD-R or CD-RWAbout MP3 MP3 disc structureHow are MP3 files recorded and played back? Loading Discs Playing Back DiscsPlaying Back the Entire Discs-Continuous Play For audio CDsTo stop play for a moment Basic Disc OperationsTo go to another track To locate a particular point in a trackProgramming the Playing Order of the Tracks -Program Play Playing at Random-Random Play To check the program contentsTo modify the program During Program Play Press Repeat during or before playDuring Random Play Playing Back a Tape Playing Back TapesRecording To record on both sides-Reverse ModeRecording on a Tape To keep the best recording and playback sound qualityLoad a disc Select a disc Synchronized RecordingUsing Daily Timer Using the TimersHow Daily Timer actually works When selecting 1 CD When selecting Tuner FM or TuneramVolume level Daily Timer settingHow Recording Timer actually works Using Recording TimerSelect the preset station Press to turn off the unit Standby standby if necessaryTimer Priority Using Sleep TimerTo turn on or off Recording Timer after it has been set How Sleep Timer actually worksCleaning the unit MaintenanceGeneral Notes Handling discsSymptom TroubleshootingCA-HXZ30 SpecificationsCA-HXZ10 Important for mains AC line SP-HXZ10 ﻢﺨﻀﳌا جﺮﺧ تﺎﻳﺎﻬﻧ Conexión رﺎﻌﺷإ نود ﺮﻴﻴﻐﺘﻠﻟ ﺔﺿﺮﻋ تﺎﻔﺻاﻮﳌاو ﻢﻴﻤﺼﺘﻟا