Creating Your Own Sound Mode-User Mode

Your individual mode stored in memory. See “Creating Your Own Sound Mode—User Mode” below.

Boosts low and high frequency. Good for acoustic music.

Good for vocal music. Good for classical music.

English

Surround modes*

DANCE: Increases resonance and bass.

HALL: Adds depth and brilliance to the sound.

STADIUM: Adds clarity and spreads the sound, as in an outdoor stadium.

SEA (Sound Effect Amplifier) modes

ROCK:

POP:

CLASSIC:

User modes

USER 1/2/3:

3	Adjust the SEA pattern.	E
		PR SET

1)Turn ¢ / 4 to select the

frequency range (BASS,	/BEEP	T
frequency range (BASS,	/BEEP	N
		U
		N
		I
MID or TRE).		G
MID or TRE).

2)Press ¡ or 1 to adjust

the level (–3 to +3) of the selected frequency range.

3)Repeat steps 1) and 2) to adjust the level of the other frequency ranges.

4 Press SET/DISPLAY again.	SET
	SET
	/DISPLAY

OFF:	The sound mode is canceled.	5	Turn ¢ / 4 to select one
			of the user modes (USER 1,
* Surround elements are added to the SEA elements to create a			USER 2, or USER 3) in which
being-there feeling in your room.			you want to store your SEA
			pattern.
	When you turn on Sound Turbo	6	Press SET/DISPLAY again.
The sound mode is canceled.		6	Press SET/DISPLAY again.

Creating Your Own Sound Mode—User Mode

You can change the SEA pattern to suit your preference. The SEA pattern can be adjusted using 3 frequency ranges—BASS, MID (middle), and TRE (treble). These changed settings can be stored as the USER 1, USER 2, and USER 3 modes.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

On the unit ONLY:

1 Select one of the preset sound modes.

•If you want to add surround elements into your SEA pattern, select one of the surround modes (DANCE, HALL, or STADIUM) before starting the procedure below. (See “Selecting the Sound Modes” on page 10.)

2 Press SET/DISPLAY while the	SET
selected sound mode is still shown	/DISPLAY
selected sound mode is still shown
on the display.

The SEA pattern you have created is stored into the user mode selected in step 5.

To use your own sound mode

Select USER 1, USER 2, or USER 3 mode when using the sound modes. See “Selecting the Sound Modes” on page 10.

When you unplug the AC power cord or if a power failure occurs

The setting will be erased in a few days. If this happens, set the user modes again.

Turning On or Off the Key-touch Tone

If you do not want the key-touch tone to beep each time you press a button or turn a control, you can deactivate it.

The BEEP ON indicator goes off from the display.

Current level appears.

On the unit:

Press and hold BEEP for more than 2 seconds.

On the remote control:

Press BEEP ON/OFF.

•Each time you press the button, the key- touch tone turns on and off alternately.

/BEEP

BEEP

ON/OFF

FADE

MUTING

VOLUME

U N I GN