Weider 16.8ST manual

22.Remove the upper 3/8Ó x 3Ó Bolt (45) from the Top Frame (1) and the Main Upright (3).

Feed the bolt on the High Cable (73) down through the indicated slot in the Main Upright (3) in the direc- tion shown.

Wrap the High Cable (73) around a 4Ó Pulley (35) in the direction shown. Attach the Pulley inside the slot in the Main Upright (3) with a 3/8Ó x 2 1/2Ó Bolt (54), two 3/8Ó Flat Washers (55), two 5/8Ó x 1/2Ó Pulley Bushings (42), and a 3/8Ó Nylon Jam Nut (63).

Re-insert the 3/8Ó x 3Ó Bolt (45) and secure it with a 3/8Ó Nylon Locknut (50). Note: The Cable (73) must be seated in the groove of the Pulley (35) before the Bolt is attached.

23.Feed the bolt on the High Cable (73) under the weld- ed tube on the Press Frame (12) as shown. Wrap the High Cable down around a 4Ó Pulley (35) in the direc- tion shown. Attach the Pulley to the Press Frame (12) with a 3/8Ó x 8 1/2Ó Bolt (59) and a 3/8Ó Nylon Locknut (50).

Wrap the High Cable (73) down around another 4Ó Pulley (35). Attach the Pulley inside the indicated slot in the Main Upright (3) with a 3/8Ó x 2 1/2Ó Bolt (54), two 3/8Ó Flat Washers (55), two 5/8Ó x 1/2Ó Pulley Bushings (42), and a 3/8Ó Nylon Jam Nut (63).

24.Wrap the High Cable (73) down around a 4Ó Pulley

(35)in the direction shown. Feed the bolt on the High Cable (73) back through the slot in the Main Upright

(3)as shown. Attach the Pulley to the Press Frame

(12)with a 3/8Ó x 8 1/2Ó Bolt (59) and a 3/8Ó Nylon Locknut (50).

22		35
			45			55	54
		Slot
	50					42	73
1
		42
	63	55
		Bolt
		3
23	Welded Tube
			73	12
						42	54
							55
	42
		35					59
63
	55						35
		55		Slot	50
							Bolt
24
							59
Slot
		73
							35
		50				12
Bolt				3

13