Assembly
Make Assembly Easier for Yourself!
Everything in this manual is designed to ensure that the training system can be assembled successfully by anyone. Before beginning assembly, make sure to read the information on this page; this brief intro- duction will save you much more time than it takes to read it!
Assembly Requires Two Persons
For your convenience and safety, assemble the training system with the help of another person.
Set Aside Enough Time
Due to the many features of the training system, the assembly process will require a few hours. By setting aside plenty of time and by deciding to make the task enjoyable, assembly will go smoothly. You may want to assemble the training system over a couple of evenings.
Select a Location for the Training System
Because of its weight and size, the training system should be assembled in the location where it will be used. Make sure that there is enough room to walk around the training system as you assemble it.
How to Unpack the Box
To make assembly as easy as possible, we have divided the assembly process into four stages. The parts needed for each stage are found in individual bags. Important: Wait until you begin each stage to open the parts bag for that stage. Place all parts of the training system in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
Make sure you have the following tools:
¥ Two adjustable wrenches
¥ One standard screwdriver
¥ One phillips screwdriver
¥ One rubber mallet
¥You will also need grease or petroleum jelly, a small amount of soapy water, and clear tape or masking tape.
Note: Assembly will be more convenient if you have a socket set, a set of
How to Identify Parts
To help you identify the small parts used in assembly, we have included a PART IDENTIFICATION CHART in the center of this manual. Place the chart on the floor and use it to easily identify parts during each assembly step. Note: Some small parts may have been
How to Orient Parts
As you assemble the training system, make sure that all parts are oriented exactly as shown in the drawings.
Tightening Parts
Tighten all parts as you assemble them, unless instructed to do otherwise.
Questions?
If you have questions after reading the assembly instructions, please call our Customer Service Department
The Four Stages of the Assembly Process
Frame AssemblyÑYou will begin by assembling | Cable AssemblyÑDuring this stage you will |
the base and the uprights that serve as the skele- | attach the cables and pulleys that connect the |
ton of the training system. | arms and other parts to the weights. |
Arm AssemblyÑDuring this stage you will | Seat AssemblyÑDuring this stage you will |
assemble the press arm and the leg lever, han- | assemble the seats, the backrests, the curl pad, |
dles, leg press, and other miscellaneous parts. | the shroud, and other miscellaneous parts. |
|
|
5