11.Press a 1 3/4Ó Square Inner Cap (44) into each end of an Arm (46).
Apply lubricant to the lower axles on the Arm Frame (52). Slide an Arm (46) onto one of the axles. Hold two 1Ó Retainers (54) and a 1Ó Round Cover Cap
(55)against the lower end of the axle. The teeth on the Retainers must bend toward the Round Cover Cap (see the inset drawing). Tap the Retainers and Round Cover Cap onto the axle.
Assemble the other Arm (46) to the Arm Frame (52) in the same manner.
12.Insert the two 4 1/2Ó ÒLÓ Pins (60) down through the indicated holes in the Arm Frame (52) and the Arms (46).
13.Wet both Arms (46) with soapy water. Slide a 7 3/4Ó Pad (45) onto each Arm.
Press a 1Ó Round Inner Cap (49) into the indicated end of a 7Ó Handle (47). Insert the Handle into one of the Arms (46). Attach the Handle with a 5/16Ó x 2 1/4Ó Bolt (33), two 5/16Ó Flat Washers (8), a 1/2Ó x 3/8Ó Spacer (51) and a 5/16Ó Nylon Locknut (3).
Attach a 7Ó Handle (47) to the other Arm (46) in the same manner.
8
11 |
|
|
|
| 52 |
| |
| Lubricate Axle | ||
|
| Bracket |
|
44 | 54 |
|
|
|
|
| |
| 55 |
|
|
|
| 44 |
|
| 46 |
|
|
|
|
| Axle |
|
| 54 |
|
|
|
| 55 |
12 |
|
|
|
|
| 60 |
|
|
| 52 |
|
| 46 |
|
|
13 |
|
|
|
| 46 | 47 | 49 |
| 3 |
| |
|
|
| |
46 | 8 | 8 |
|
|
| ||
|
|
| |
45 | 49 |
|
|
| 51 | 33 | |
| 45 |
|
|
47 |
|
|
|