Weider WESY85070 user manual Following Tools not Included are Required for Assembly

ASSEMBLY

Assembly requires two people. Due to the size and weight of the home gym system, assemble it in the location where it will be used.

¥Place all parts of the home gym system in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed.

¥Before beginning, read each assembly step and look at each drawing carefully.

¥For help identifying small parts used in assembly, refer to the PART IDENTIFICATION CHART attached to the center of this manual.

¥During assembly, be sure that all parts are orient- ed as shown in the drawings.

¥Tighten all parts as you attach them, unless instructed to do otherwise.

THE FOLLOWING TOOLS (NOT INCLUDED) ARE REQUIRED FOR ASSEMBLY:

¥Two (2) adjustable wrenches

¥One (1) phillips screwdriver

¥One (1) rubber mallet

¥Lubricant, such as grease or petroleum jelly, and soapy water are also required.

To simplify assembly, the following tools are recom- mended: A socket set, open or closed wrenches, or ratchet wrenches.

1. Before you begin, make sure that you have	1
carefully read the instructions at the top of
this page.		88
Press a 2Ó Square Outer Cap (88) onto each end	3
of the Stabilizer (71). Press a 2Ó Square Outer	71
Cap onto each side of the Base (4). Press a 2Ó
	88
Square Inner Cap (27) into the end of the Base.
Insert two 5/16Ó x 2 1/2Ó Carriage Bolts (1) up	1	4
through the Stabilizer (71). Insert two 5/16Ó x	88
2 1/2Ó Carriage Bolts up through the Base (4).		1
Slide the indicated end of the Base (4) onto the		27
5/16Ó x 2 1/2Ó Carriage Bolts (1) in the Stabilizer
(71). Tighten a 5/16Ó Nylon Locknut (3) onto each
Carriage Bolt.	2	72
2. Set two Weight Bumpers (19) onto the Base (4)
as shown.
Slide the Weight Guides (72) into the Base (4).	19
Attach each Weight Guide to the Base with a	3
5/16Ó x 2 3/4Ó Bolt (11), two 5/16Ó Washers (8),
two 1/2Ó x 1/2Ó Spacers (65), and a 5/16Ó Nylon	8	65
Locknut (3).
		8
	8
	65	4
		11

4