Weider WESY39310 user manual Locknut the Pulley Bracket must be able to move freely

18.Wrap the High Cable (58) around a “V”-Pulley (50). Attach the “V”-Pulley and a Long Cable Trap (31) to the indicated bracket on the Front Upright (42) with a 3/8” x 2 1/2” Bolt (86) and a 3/8” Nylon Locknut (21). Be sure that the Long Cable Trap is posi- tioned to hold the Cable in place.

19.Route the High Cable (58) around the “V”-Pulley (50) on the Left Arm (47). Be sure that the Cable is in the groove of the Pulley and that the Long Cable Trap (31) is positioned to hold the Cable in place. Tighten the 3/8” x 2 1/2” Bolt (86) and the 3/8” Nylon Locknut (not shown).

20.Route the High Cable (58) around the “V”-Pulley (50) on the Right Arm (48). Be sure that the Cable is in the groove of the Pulley and that the Long Cable Trap (31) is turned to hold the Cable in place. Tighten the 3/8” x 2 1/2” Bolt (86) and the 3/8” Nylon Locknut (not shown).

21.Attach the Pulley Bracket (20) to the Top Frame (55) with the 5/16” x 5” Bolt (68) and a 5/16” Nylon Locknut (3). Do not over tighten the Nylon

Locknut; the Pulley Bracket must be able to move freely.

See the inset drawing. Route the High Cable (58) around the 3 1/2” Pulley (15) attached to the Pulley Bracket (20). Tighten the 3/8” x 2” Bolt (12) and the 3/8” Nylon Locknut (not shown). Be sure that the

Cable is in the groove of the Pulley and that the Cable Trap (66) is turned to hold the Cable in place.

12

18
			86	31
		58		50
				Bracket
		21
		42
19
		50	86	31
		58	47
20
		31	86	50
		58		48
21		68
	55		66
20			12
				15
		3
			58