25. Locate the Low Cable (23) and the bag labeled |
“LOW PULLEY.” Route the Low Cable under the |
3 1/2” Low Pulley (76). Attach the Pulley and the |
5/8” x 9/16” Spacer (7) to the Press Frame (17) with |
a 3/8” x 3 3/4” Bolt (88), 3/8” Washer (9), and a 3/8” |
Nylon Locknut (21). Be sure that the parts are ori- |
ented as shown in the drawing, and that the end |
of the Cable with the ball is on the indicated |
side of the Press Frame, between the Pulley and |
the crossbar. |
25 |
76
Ball
23
17
Crossbar
88
9
7
1776
21
26. Route the Low Cable (23) around a 3 1/2” Pulley |
(15). Attach Pulley and a Cable Trap (66) to the |
lower hole in the Front Upright (42) with a 3/8” x |
3 3/4” Bolt (88), a 3/8” Washer (9), and a 3/8” Nylon |
Locknut (21). See the inset drawing. Be sure that |
the Cable Trap is turned to hold the Cable in |
place and that the Cable is routed around the |
Pulley as shown. |
26
42
15 66 21
23
23 15
21
66
42
Inset shows view
from other side
27. Route the Low Cable (23) around a 3 1/2” Pulley |
(15). Attach the Pulley and a Cable Trap (66) to the |
upper hole in the Press Frame (17) with a 3/8” x |
3 1/2” Bolt (16), a 3/8” Washer (9), and a 3/8” Nylon |
Locknut (21). Be sure that the Cable Trap is |
turned to hold the Cable in place and that the |
889
27
23
9
Cable is routed around the Pulley as shown. |
15
16
17
21 66
28.Route the Low Cable (23) around another 3 1/2” Pulley (15). Attach the Pulley and a Cable Trap (66) to the upper hole in the Front Upright (42) with a 3/8” x 3 3/4” Bolt (88), a 3/8” Washer (9), and a 3/8” Nylon Locknut (21). See the inset drawing. Be sure that the Cable Trap is turned to hold the Cable in place and that the Cable is routed around the Pulley as shown.
28
42
23
66 21
15
23 15
88
66
42
Inset shows view
from other side
9
88
14