Weider WESY39310 user manual Do not tighten the Nylon Locknuts yet

Page 6

2.Slide the Rear Upright (74) and the Leg Press Upright (56) onto the indicated 5/16” x 2 1/2” Carriage Bolts (1) in the Stabilizer (5). The high side of the brackets on the Rear Upright and Leg Press Upright should be on the side shown.

Hand tighten four 5/16” Nylon Locknuts (3) onto the Carriage Bolts. Do not tighten the Nylon

Locknuts yet.

Press a 2” Square Inner Cap (27) into the Leg Press Upright (56). Press a 2” Square Inner Cap into the Rear Upright (74).

Attach the Rubber Bumper (91) to the Leg Press Upright (56) with the #8 x 1/2” Self-tapping Screw (87).

3.Slide the Front Upright (42) onto the 5/16” x 2 1/2” Carriage Bolts (1) in the Base (4). Hand tighten a 5/16” Nylon Locknut (3) onto each Carriage Bolt.

Do not tighten the Nylon Locknuts yet.

Press a 1” Square Inner Cap (6) into the Front Upright (42).

6

2		27
	27	27
	27
	87	High Sides
		High Sides
	91	of Brackets
74	91
74
		56
		3
	3
		5
3		1
		1
	1
3
		42
		6
		3
	4
		1

Image 6

Contents QUESTIONS? Model No. WESY39310 Serial NoCustomer HOT Line Table of Contents Important Precautions Before YOU Begin Decal NoFollowing Tools not Included are Required for Assembly AssemblyChart located in the center of this manual Questions?Locknuts yet Do not tighten the Nylon Locknuts yetTighten all 5/16 Nylon Locknuts 3 used in steps On the Weight Tube is sitting in the pin grooves Top Weight Weight Guides are at the top, as shownHoles in the Weight Guides are at the top, as Shown Locate and open the parts bag labeled ARM Assembly Nylon Locknut the Leg Press Arm must be able to pivot freelyNylon Locknut yet Cable Assembly Locknut the Pulley Bracket must be able to move freely Page 2 Low Pulley 76. Attach the Pulley Locate the Low Cable 23 and the bag labeledLOW PULLEY. Route the Low Cable under X 9/16 Spacer 7 to the Press Frame 17 withPage Cable Trap is positioned to hold the Cable in place Page Seat Assembly Locate and open the parts bag labeled Seat AssemblyPage Page Adjustments Changing the Weight SettingAdjusting the LEG Press Plate Attaching and Removing the SeatAttaching the LEG Lever to the LOW Pulley Station Weight Resistance Chart PlatesTROUBLE-SHOOTING and Maintenance Tightening the CablesCable Diagrams TOP ViewMilitary Press Cable 72 and Leg Press Cable Leg Press CableExploded DRAWING-Model No. WESY39310 Page Page Part LIST-Model No. WESY39310 Exploded Drawing Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT