Technics WX-H3050 manual English Version

Page 2

ENGLISH VERSION

For U.S.A.

FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

FCC Warning: This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.

FCC Warning: The available scientific evidence does not show that any health problems are associated with using low power wireless devices. There is no proof, however, that these low power wireless devices are absolutely safe. Low power wireless devices emit low levels of radio frequency energy (RF) in the microwave range while being used. Whereas high lev- els of RF can produce health effects (by heating tissue), exposure to low-level RF that does not produce heating effects causes no known adverse health effects. Many studies of low-level RF exposures have not found any biological effects. Some studies have suggested that some biological effects might occur, but such findings have not been confirmed by addi- tional research. WX-H3050 has been tested and found to comply with FCC radiation exposure limits set forth for an uncon- trolled equipment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65.

FCC Warning: To assure continued FCC emission limit compliance, use only the provided power supply cord and shielded interface cable when connecting this device to the computer. Also, any unauthorized changes or modifications to this equip- ment would void the user's authority to operate this device.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Responsible Party:

Panasonic Corporation of North America

 

One Panasonic Way, Secaucus, NJ 07094

Technical Support Party:

Panasonic Consumer Electronics Company

 

1707 N. Randall Rd., Elgin IL. 60123

Technical Support Tel No.:

886-472-6767

For Canada

ICES-003

This Class A digital apparatus complies with Canadian ICES-003.

For Canada

RSS-213

Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

CAUTION:

Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

These servicing instructions are for use by qualified service per- sonnel only. To reduce the risk of electric shock do not perform any servicing other than that contained in the operating instruc- tions unless you are qualified to do so.

2

For U.S.A.

CAUTION

The FCC ID number for this radio equipment is listed below.

FCC ID: ACJ9TAWX-H3050

For U.S.A.

The model number and serial number of this product may be found on the surface of the unit.

You should note the model number and serial number of this unit in the space provided and retain this book as a perma- nent record of your purchase to aid identification in the event of theft.

Model No.

Serial No.

Image 2
Contents Operating Instructions English Version Disclaimer of Warranty Limitation of LiabilityImportant Safety Instructions Contents Preface FeaturesPrecautions Major Operating Controls and Their Functions Microphone 0Lane Indicator Battery Lock EjectPower Button Power 1Power IndicatorReplacement Battery Loading & ReplacementInstallation LoadingOperating Procedures PreparationsCommunications with Customers Talk Communications with Other Store PersonnelControl of the device control ter- minals Double-Drive-Thru connectionsManager Mode Only one head- set Canceling the Manager ModeAuto-Talk-Lock setup for only one headset Maintenance DIP Switch Setup Setup ProceduresOpening the Switch Compartment ID Registration Deletion of IDTroubleshooting SymptomSpecifications Standard Accessories Optional AccessoriesVersion Française Limitation de responsabilité Déni de la garantieInstructions de sécurité importantes Table DES Matières Mesures de précaution PréfaceCaractéristiques dominantes Principaux organes de commande et fonctions Microphone 0Indicateur de passage Bouton dalimentation PowerRembourrage découteur Perche de microphone 1Indicateur dalimentationChargement Chargement et remplacement de la batterieRemplacement RemarquesModes dutilisation PréparatifsCommunications avec les Clients Talk Communication avec dautres membres du personnel du MagasinBornes de commande de Périphérique extérieur Double-Drive-ThruMode de gérant seulement un Combiné microcasque découte Annulation du mode gérantAuto-Talk-Lock Coussin découteur Ouverture du logement de Commutateur Procédures de configurationConfiguration dinterrupteur DIP Enregistrement didentification Suppression dune identificationDépannage SymptômeCaractéristiques techniques Accessoires standard Accessoires optionnelsPanasonic Sales Company Panasonic System Solutions CompanyPanasonic Canada Inc