Technics WX-H3050 manual Auto-Talk-Lock setup for only one headset

■Auto-Talk-Lock setup (for only one headset)

For a headset where Auto-Talk-Lock is set up, it has a func- tion to select [Talk] automatically when the vehicle detector has become active, and you can talk with the customer at the menu board.

1.Confirm that the DIP Switch 1 of the headset is ON, the DIP Switch 2 is set at the objective lane, and the power of the headset is OFF.

Power button

2.Turn on the headset. The message "Hello Headset **" (** is the number of headset) is output from the speaker of the headset, and the power indicator blinks green and red alternately for 3 seconds. While the indicator is blink- ing, press the T1 or T2 button. (LANE A: T1 button, LANE B: T2 button)

Auto-Talk-Lock will be set up, The message "Auto-Talk- Lock ON" is heard from the speaker of the headset. When the T1 or T2 button is not pressed, the headset assumes an ordinary operation mode.

3.In the case of a failure in Auto-Talk-Lock setup, a voice of [Failed] is heard from the speaker of the headset. In this case, the same procedures should be followed from Step 1 again.

Note: If the power of the headset is turned OFF, all the set- ting conditions for Auto-Talk-Lock will be canceled. This setting should be carried out without fail when the power supply is started up.

14