Daewoo DWF-176S Residual Time Display, Drain Motor, HOW to Replace Lint Filter, Structure

Page 12

LINT FILTER

Much lint may be obtained according to the kind of clothes to be washed and some of the lint may also sticks to the clothes.

To minimize this possibility a lint filter is provided on the upper part of the tub to filter the wash water as it is discharged from the water channel. It is good to use the lint filter during washing.

HOW TO REPLACE LINT FILTER

Filter

Bleach

Inlet

Pulsator

1Pull the filter frame upward.

2Turn the lint filter inside out, and wash the lint off with water.

3 Return the filter as it was, and fix the filter frame to the slot.

RESIDUAL TIME DISPLAY

When the START/HOLD button is pressed, the residual time (min.) is displayed on the time indicator, and it will be counted down according to process.

When operation is finished, the TIME INDICATOR will light up .

DRAIN MOTOR

STRUCTURE

Pull

Loosen

FUNCTIONAL PRINCIPLE

Pulley

Lever

Inductive ring

Magnet

Coil of motor Magnet of motor

1When the DRAIN MOTOR connected to the power source, the DRAIN MOTOR rotates with 900 r.p.m and revolves the pulley by gear assembly for reducing.

2When the pulley is rotated, the pulley winds the wire to open the drain valve.

3 Therefore, rotation of pulley changed to the linear moving of wire.

4 The wire pulls the brake lever of Gear Mechanism Ass’y within 5 seconds.

5 After the wire pulled, gear assembly is separated from motor and condition of pulling is held by operation of the lever.

6 When the power is turned off, the drain valve is closed because the wire returns to original position.

FEATURE 11

Image 12
Contents Auto Washer Washing Machine Specifications DWF-176SStructure of the Washing Machine HOT Water TAPDirections for Installation and USE Installing PlaceFor Ordinary TAP For SCREW-SHAPED TAPCleaning the Lint Filter Cleaning the Water Inlet FilterCleaning the Drain Filter 4Clean the drain filter removing the foreign stuffsFeature and Technical Explanation Feature of the Washing MachineWater Current to Adjust the Unbalanced Load Function for Soak WashAutomatic Drainning Time Adjustment Functional Principle of Bubble Washing MachineAcross Section Functional PrincipleAutomatic Unbalance Adjustment CIRCULATING-WATER Course and Lint FilterCIRCULATING-WATER HOW to Replace Lint Filter Lint FilterResidual Time Display Drain MotorGear Mechanism ASS’Y Directions for Disassembly and Adjustment Gear Mechanism ASS’Y ReplacementGear Mechanism Assy Replacement Pull out the gear mechanism assy Motor Synchronous and Valve Replacement NON Pump Model Structure of Gear Mechanism Alternative Tool for Replacing the Clutch Boss AssembleHOW to Check the Clutch Spring Problem ProblemProcess of Disassemble ProcessProcess Process of Assemble Boss3.5~4.5mm Replace the Case Filter ASS’Y Trouble Shooting Guide Concerning Water SupplyConcerning Washing Water Supply is Not StoppedConcerning Draining Concerning Spinning Spin No YESConcerning Operation Concerning Error Message Message Cause SolutionPresentation of the P.C.B ASS’Y Wiring Diagram AppendixNON-PUMP, Single Valve Pump Parts Diagram Parts Diagram Parts Diagram Parts List PCB AS T2S TRS 4X16 Mfzn Circuit Diagram Printed Date Feb