Daewoo Auto Washer, DWF-176S service manual Directions for Installation and USE, Installing Place

Page 5

3. DIRECTIONS FOR INSTALLATION AND USE

INSTALLING PLACE

Install the washer on a horizontal solid floor. If the washer is installed on an unsuitable floor, it could make considerable noise and vibration.

10Cm

Keep the machine body more than 25cm apart from the wall surface. It will make easy cleaning the drain filter which is equipped at the back side of it. And if it comes into contract vibra- tion may occur.

Never install in these

The place where it would be exposed to direct sunlight.

The place nearby a heater or heat appli- ance.

The place where it would be supposed to be frozen in winter.

The kitchen with coal gas and a damp place like a bathroom.

INSTALLATION OF THE UNDER BASE COVER [OPTION]

The packing box

 

Push the noise insulation plate

 

 

 

1 opened, there is a

 

2 into the end, which decrease

 

noise insulation plate

 

the noise made by this washer.

 

at the bottom of the back

 

 

 

 

 

 

 

 

 

 

 

HOW TO INSTALL ON AN INCLINED PLACE

Horizon

Check the Horizon

1 Setting

2 Status

After controlling the height

Check the position of tub above

by turning the adjustable

the center of the washer.

leg, let the washer put

 

down to the ground.

 

NOTES

The openings must not be obstructed by carpet- ing when the washing machine is installed on a carpeted floor.

4DIRECTIONS

Image 5
Contents Auto Washer Washing Machine DWF-176S SpecificationsHOT Water TAP Structure of the Washing MachineInstalling Place Directions for Installation and USEFor SCREW-SHAPED TAP For Ordinary TAPCleaning the Water Inlet Filter Cleaning the Lint Filter4Clean the drain filter removing the foreign stuffs Cleaning the Drain FilterFeature of the Washing Machine Feature and Technical ExplanationWater Current to Adjust the Unbalanced Load Function for Soak WashFunctional Principle of Bubble Washing Machine Automatic Drainning Time AdjustmentAcross Section Functional PrincipleCIRCULATING-WATER Automatic Unbalance AdjustmentCIRCULATING-WATER Course and Lint Filter Lint Filter HOW to Replace Lint FilterResidual Time Display Drain MotorGear Mechanism ASS’Y Gear Mechanism Assy Replacement Directions for Disassembly and AdjustmentGear Mechanism ASS’Y Replacement Pull out the gear mechanism assy Motor Synchronous and Valve Replacement NON Pump Model Alternative Tool for Replacing the Clutch Boss Assemble Structure of Gear MechanismProblem HOW to Check the Clutch Spring ProblemProcess Process of DisassembleProcess Process of Assemble Boss3.5~4.5mm Replace the Case Filter ASS’Y Concerning Water Supply Trouble Shooting GuideWater Supply is Not Stopped Concerning WashingConcerning Draining Spin No YES Concerning SpinningConcerning Operation Presentation of the P.C.B ASS’Y Concerning Error MessageMessage Cause Solution Appendix Wiring DiagramNON-PUMP, Single Valve Pump Parts Diagram Parts Diagram Parts Diagram Parts List PCB AS T2S TRS 4X16 Mfzn Circuit Diagram Printed Date Feb