Daewoo DWF-176S, Auto Washer service manual For Ordinary TAP, For SCREW-SHAPED TAP

Page 6

■HOW TO CONNECT THE INLET HOSE

Be careful not to mistake in supplying between the hot(maximum : 50˚C) and cold water.

In using only one water tap or in case of attached one water inlet valve, connect the inlet hose to the cold water inlet valve.

Do not over tighten : this could cause damage to couplings.

FOR ORDINARY TAP

1 Pull down the collar of the inlet hose to separate it from the water tap adapter.

4Remove the tape, and screw connector B into connect A tightly.

Connector A

Connector B

2Loosen the four screws at the water tap adapter, but don’t loosen the screws until they are separated from the water tap adapter.

5Connect the inlet hose to the water tap adapter by puling down the collar of the hose end.

3Connect the water tap adapter to the water tap tight- en the four screws evenly while pushing up the adapter so that the rubber packing can stick to the water tap tightly.

TAPE

6Connect the inlet hose adapter of the hose to the water inlet of the washer by turning it clock- wise to be fixed tightly.

•Please check the rubber packing inside the inlet hose adapter of the hose.

FOR SCREW-SHAPED TAP

1 Connect the inlet hose to the water tap by screwing the con- nector D tightly.

 

Rubber

Connector D

Packing

2Connect the connec- tor-inlet supplied if necessary.

Connector

Inlet

 

Rubber

Connector D

Packing

 

3Insert the inlet hose adapter into the water inlet of a washer and turn it to be fixed.

Inlet Hose

Connector C

Hose

 

 

Connector C

• Assert the packing in the inlet

CONNECTION 5

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Auto Washer Washing Machine Specifications DWF-176SStructure of the Washing Machine HOT Water TAPDirections for Installation and USE Installing PlaceFor Ordinary TAP For SCREW-SHAPED TAPCleaning the Lint Filter Cleaning the Water Inlet FilterCleaning the Drain Filter 4Clean the drain filter removing the foreign stuffsWater Current to Adjust the Unbalanced Load Feature and Technical ExplanationFeature of the Washing Machine Function for Soak WashAcross Section Automatic Drainning Time AdjustmentFunctional Principle of Bubble Washing Machine Functional PrincipleAutomatic Unbalance Adjustment CIRCULATING-WATER Course and Lint FilterCIRCULATING-WATER Residual Time Display HOW to Replace Lint FilterLint Filter Drain MotorGear Mechanism ASS’Y Directions for Disassembly and Adjustment Gear Mechanism ASS’Y ReplacementGear Mechanism Assy Replacement Pull out the gear mechanism assy Motor Synchronous and Valve Replacement NON Pump Model Structure of Gear Mechanism Alternative Tool for Replacing the Clutch Boss AssembleHOW to Check the Clutch Spring Problem ProblemProcess of Disassemble ProcessProcess Process of Assemble Boss3.5~4.5mm Replace the Case Filter ASS’Y Trouble Shooting Guide Concerning Water SupplyConcerning Washing Water Supply is Not StoppedConcerning Draining Concerning Spinning Spin No YESConcerning Operation Concerning Error Message Message Cause SolutionPresentation of the P.C.B ASS’Y Wiring Diagram AppendixNON-PUMP, Single Valve Pump Parts Diagram Parts Diagram Parts Diagram Parts List PCB AS T2S TRS 4X16 Mfzn Circuit Diagram Printed Date Feb
Top Page Image Contents