Electrolux 88840 manual Machine is

Operating Instructions

Problem	Possible Cause	Remedy
The drain pump runs		Close the water tap, remove
constantly, even when	The Aqua Control anti-flood	the mains plug and inform
the machine is	system has been activated.	your local Service Force Cen-
switched off.		tre.
Fabric softener was	The insert in the compart-	Clean the detergent
not rinsed in, the æ	ment for conditioners is not	dispenser drawer and attach
compartment is filled	correctly attached or is	the conditioner insert cor-
with water.	blocked.	rectly.
		Pay attention to the maxi-
		mum load quantity (see the
The washing is heavily	Probably too much washing	Programme Tables). In the
creased.	has been put in the drum.	case of easy-care fabrics, se-
		lect the EASY IRON pro-
		gramme.
	The drain hose is kinked.	Remove the kink.
	The maximum pump height	Contact your local Service
		Force Centre. For pumping
	(outlet height 1m from the
Washing is not spun		heights over 1 m a conver-
	base surface of the appli-
thoroughly and water		sion kit is available as a spe-
	ance) is exceeded.
remains visible in the		cial accessory.
drum.
		Switch off the machine and
Fault code (2 appears.
	The drain pump is blocked.	disconnect the mains plug.
		Clean the drain pump.
	For siphon attachments: the	Clean the siphon.
	siphon is clogged
	The door is locked for safety	Wait until DOOR indicator
	reasons (the DOOR indicator
		is lit green.
	is not lit).
The door cannot be
opened when the	The Programme Protection is	Release the Programme Pro-
washing machine is		tection (see "Programme
switched off.	set.	Protection").
	The washing machine is in	Press the DOOR button
	Stand-by mode.	again.

36