Electrolux 88840 manual What to do if, Trouble Shooting, Low

Page 34

Operating Instructions

What to do if...

Trouble Shooting

If the appliance is not working correctly, please carry out the following checks before contacting your local Service Force Centre. Important: If you call out an engineer to a fault listed below or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is in guarantee.

• If the fault code C1 oder C2 is shown in the multi-display, you may be able to remedy the fault yourself (see the Fault table be-

low).

After clearing the fault, press the START/PAUSE button. If the fault code is shown again, contact your local Service Force Centre.

•For all other faults displayed in the multi-display, please contact your local AEG Service Force Centre, stating the fault code.

Problem

Possible Cause

Remedy

 

The mains plug is not in-

Insert the mains plug.

 

serted.

 

 

 

The house fuse has blown.

Replace the fuse.

The washing machine

The door is not closed prop-

Close the door - there should

does not work.

erly.

be an audible click.

 

 

The START/PAUSE button

Press and hold the START/

 

was not pressed for long

PAUSE button until the pro-

 

enough.

gramme starts.

The door cannot be

The child safety device is

Release the child safety fea-

ture (see section "Child

closed.

switched on.

safety feature").

 

 

 

The water tap is closed.

Open the water tap.

 

The filter in the socket of the

Close the water tap. Discon-

Water is not entering.

nect the hose from the water

inlet hose connection is

tap, remove the filter and

Fault code (1 appears.

blocked.

clean under running water.

 

 

 

Water tap is blocked with

Check the water tap and

 

limescale or is faulty.

have it repaired if necessary.

 

 

 

34

Page 33 Page 35
Image 34
Page 33 Page 35
Contents ÖKO-LAVAMAT 88840 update Future owners Dear CustomerPages of this instruction book ApplianceContents Installation and connection instructions Page Prior to initial start-up SafetyIntended Use Child Safety General SafetyEnvironmental tips When disposing of the washing machineDisposal PackagingFront view Description of the ApplianceDetergent dispenser drawer Control panel Programme selectorWool / P Handwash Silk / P HandwashProgramme option buttons PRE-WASH Pre-wash/SoakingProgrammable functions Time SaverWash Time Display Consumption values and programme timesAnce spin detection and foam detection What does Update mean? Anti-flood Aqua Control + Aqua AlarmPreparing for a wash cycle Before the first washSorting and preparing the washing Types of washing and care symbols Water softening How much detergent and conditioner?Water hardness details Brief instructions Running a washing cycleAfter the washing programme has ended Setting the wash programme BlesSILK/PHandwash Selecting Spin Speed /Rinse HoldWOOL/PHandwash Cannot be changedPress the PRE-WASH button Press the Delay Timer button Setting the Delay Timer/Soaking timeSoaking time Automatically after approximately 3 minutes Opening and closing the doorLoading the washing For maximum loads, see Programme TablesCompartment for Pre-wash detergent Soaking agent Adding detergent/conditionersCompartment for main wash deter- gent Or for water softenerIf the Delay Timer is set If using liquid detergents/tabletsStarting the wash programme Wash programme progress Washing cycle complete/removing the washing Programme Progress DisplayDetergent was used in the washing programme just com Programme Tables WashingSeparate Rinsing/Conditioning/Starching/Treating Separate SpinningMaintenance and Cleaning Washing Machine Drum Maintenance WashTo run a maintenance wash Main doorCleaning the drain pump Before cleaning the drain pumpWhat to do if Trouble ShootingLow Machine is not level Machine is Water tap is not fully Turn the water tap on fully Opened If after the last rinse foam is still visible If the washing results are not satisfactoryIf there are still grey stains on the washing If there are white residues on the washingCarrying out an emergency emptying Have a flat container on hand to catch the waterEmergency unlocking of the door When the water is completely drainedUnlock feature Supply firstHelpful to rinse with extra water To cancel the additional rinseAdditional rinse cycle RINSE+ To set the additional rinseAdditional rinse cycle and water cooling To cancel water coolingWater cooling To set the water cooling functionVariomatic spin To cancel Variomatic SpinTo set Variomatic Spin Cancelling the Programme Protection Setting the Programme ProtectionProgramme Protection Washing programme can be Child Safety FeatureCancelling the child safety feature StartedInstallation and connection instructions Installation Safety PrecautionsTransporting the appliance Installation of the applianceWhen transporting the unit with a sack trolley Remove transport packagingCover the hole with the cap G Installation-Site preparation Installation on a Suspended FloorLevelling the appliance Measures not be observed Electrical ConnectionEarth Blue Neutral Brown Live Permanent Connection Disposed of safelyWater connection Water pressureInlet Hose Connection Connection to the machineWater Drainage Pump head of greater than 1m Dimensions Technical dataDimensions in mm Warranty conditions Great BritainPage Page Page Index PNC Service & Spare Parts0870 5 929 Help us to help you Customer CareAEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG
Top Page Image Contents